Get matched with top roofers in Teaneck, NJ

It’s possible to install your chimney cap in some areas, but it’s usually better to hire a professional. Before you attempt a DIY chimney cap installation, check to see if your local building department requires a permit. If it does, you should hire a professional to pull the permit and complete the work for you. Even if you don’t need a permit, getting up on your roof is dangerous, especially if you have an aggressive pitch or slippery roof material, like metal. Hiring a chimney professional guarantees the job is done correctly and keeps you safe from injury.

Unfortunately, there’s no definitive answer to this question, but the wind rating of your shingles will give you a good idea of what wind speeds can damage your roof. If you’re concerned about damage, inspect your roof following windy conditions to look for signs of wind damage to your shingles. When in doubt, consider hiring a professional who fixes roofs to carry out an expert inspection. Remember that hurricanes, tropical storms, and tornadoes are likely to cause the most damage, but even severe thunderstorms can bring winds that compromise your roofing system.

Costs vary by repair scope, materials needed, and labor, with average repairs ranging from $300 to $1,000, contingent on roof size.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.