Get matched with top roofers in Ridgefield, NJ

You can put new shingles over old shingles, but most municipalities only allow for two layers of shingles before you have to rip off the old roof and start fresh. In some areas, only a single layer of shingles is allowed due to the weight a bundle of shingles adds to your structure. In most cases, it’s a good idea to remove your old shingles before you install new shingles, especially if you suspect that a roof leak may have compromised the decking underneath.

While two-layer torch down roofs are easier to install than three-layer roofing, it is best not to DIY the installation. Torch down roofs require expert knowledge of the application process to get it right the first time and prevent leaks or poor craftsmanship, not to mention that roof work can be dangerous.

Fall is widely considered the best time of year to replace a roof. The moderate temperatures are ideal for roofing crews to work and for new shingles to seal properly. Additionally, autumn weather is often drier, reducing the risk of weather-related delays compared to the rainier spring season.

While spring is also a viable option, the higher chance of rainfall can slow down the project. The main drawback to a fall installation is that it's the peak season for roofers, which can lead to higher prices and scheduling challenges.

To potentially save money, you could consider scheduling your roof replacement during the summer or winter off-seasons. However, both seasons have significant disadvantages. Extreme summer heat can make shingles too soft to handle, while winter's cold, snow, and ice can create dangerous working conditions and prevent shingles from sealing correctly, as they typically require temperatures above 40-45°F.

The most important thing to remember when laying shingles is to work from the bottom of the slope to the top. This leaves you with a top overlap that directs runoff from one row to the next until it reaches the eave for disposal. You should also make sure you follow the manufacturer's instructions and the local building code for nailing patterns and frequency so all of your hard work stays put through varying weather conditions.