Get matched with top water heater pros in Davidson, NC

Venting a gas water heater out of the roof is preferable in most cases. Heated exhaust gases naturally rise, so a vertical vent pipe is efficient. If you’re trying to vent through a pipe exiting a wall, the angle of the pipe may be more horizontal than vertical, making the venting system less effective. If you go through a wall, you may need to add a fan to ensure a successful expulsion of the gases outdoors.

The chemicals in a water softener can wear down the anode rod in the heater and shorten its life span. However, for most people, the benefits of the softener outweigh this potential drawback.

Have a plumber inspect the anode rod annually for damage, as replacing the anode rod is far less expensive than replacing the entire water heater.

The time it takes to install or replace a water heater depends on the type of heater and the complexity of the job. A professional can typically replace a standard tank-style water heater in one to three hours. However, if the work area is tight, such as a small closet or crawl space, the job could take four to five hours. Replacing an existing tankless unit takes about two to three hours, while upgrading from a tank-style to a tankless water heater is more complex and can take four to six hours. The project will take longer if you are switching fuel sources, such as installing a gas heater which can add about an hour to the timeline, or if the unit needs to be relocated.

Several signs indicate your water heater may be failing or in need of replacement. Key indicators include:

• Age: A water heater older than ten years is approaching the end of its typical lifespan.

• Water Quality: If you notice rusty or discolored water from your hot water faucets, or a foul odor similar to rotten eggs or sulfur, it can signal internal corrosion.

• Unusual Noises: Banging, rumbling, or popping sounds from the tank often mean sediment has built up, causing the unit to overheat.

• Leaks: Any water pooling around the base of the tank or visible leaks are clear signs of failure.

• Performance Issues: A decline in performance, such as water not getting hot enough, taking longer to heat up, low water pressure, or decreased efficiency, suggests the unit is struggling.

• Visible Damage: Obvious rust and corrosion on the exterior of the tank can indicate a more serious internal problem.

While these signs often point to replacement, some issues may be fixable. It's best to consult a professional plumber to diagnose the problem before investing in a new unit.