Get matched with top countertop and backsplash pros in Colfax, NC

Yes, you can install a new layer of laminate over an existing laminate countertop, which can save you time and money while updating its appearance. The process is similar to installing laminate directly onto particle board. First, clean the existing countertop thoroughly. Next, fill and sand any cracks or damaged areas. Then, you'll need to sand or scratch up the entire surface to help the contact cement or glue adhere properly. After applying the adhesive, you can install the new laminate layer on top. If you're looking for other ways to improve your existing laminate countertops, you could also consider painting them or applying an epoxy finish.

Porcelain is a relatively affordable, mid-range countertop material. It typically costs between $50 to $70 per square foot.

Compared to quartz, porcelain is slightly more affordable, as quartz generally ranges from $50 to $200 per square foot. However, lower-quality, builder's grade quartz can be similar in price to porcelain.

Compared to granite, the price can be similar, depending on the quality of the stone. While granite slabs can range from $50 to $200 per square foot, you can find lower-end granite in the same price range as porcelain. High-end granites will cost significantly more.

Porcelain is generally more expensive than laminate, acrylic, and ceramic, but less expensive than high-end slate, concrete, and marble. A key benefit is that porcelain does not require sealing, which reduces long-term maintenance costs.

The least expensive way to build a kitchen countertop is to choose an affordable material. For example, laminate countertops cost about $1,250, while Corian® countertops cost $4,000 on average. Common wood and laminate tend to be the most affordable and DIY-friendly, which will save you the cost of labor. Otherwise, look for lower-end solid surface countertops or ceramic and stone tile. These cost less than natural stone slabs.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.