Top-rated water softener pros.

Get matched with top water softener pros in Truman, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your water softener service project in Truman, MN?

Select your specific project to find the pro for you.

Find Water softener pros in Truman

Culligan Water Conditioning
5.0(
1
)
Water Treatment & Purification System - Install or ReplaceWater Treatment & Purification System - Repair or Service

Serving Truman, MN and surrounding areas

In business since 1949

Free estimates

Credit card accepted

Serving all of South Central Minnesota and beyond, the professionals at Culligan Water Conditioning are the go-to, full service water conditioning specialists you can trust! Call now for a consultation! Over 60 years in business!

Response time2 hrs
Recommended by100%of homeowners
Water Softeners questions, answered by experts

A tankless water heater should be at least 10 feet away from a water softener, although the pros you hire for water softener installation can help you determine the correct distance. These two units need to have some distance between them to prevent hot water from the tankless water heater from flowing backward into the water softener when it runs a regeneration cycle.

Hard water is not considered unhealthy and is safe to drink, cook with, and bathe in. It doesn't pose a risk to your physical health and can even help you get enough essential minerals like calcium in your diet. However, it can negatively affect skin and hair. Using hard water for washing can contribute to dry skin, an itchy scalp, and may worsen conditions like eczema by altering the pH balance. Additionally, some people do not like the taste of hard water.

Whether you need a license or permit for water softener installation depends on your location. Some municipalities require the installer to hold a plumbing license, while others may only require a permit and an inspection. In some cases, both a permit and a licensed installer are necessary, and some areas have no requirements at all. Often, only certified plumbers and electricians are allowed to pull the necessary permits. To find out the specific regulations in your area, you can contact your local building department. Alternatively, a local water softener installer or plumber will be familiar with the requirements and can typically pull the permits for you. Regardless of local laws, it is always recommended to hire a licensed professional to ensure the system is sized and installed correctly. You can use tools like Angi’s state licensing tool to verify an installer's license status.

You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips. 

The process of inspecting your water softener system is similar.

The average cost to install a water softener, including the system and labor, is approximately $1,500. However, the total price can range widely from $600 to $6,000. For some complete systems, the cost may be between $800 and $2,500. Labor for the installation typically costs between $150 and $1,000.

The final price is influenced by several factors, including:

  • System type, capacity, and complexity

  • Home size and household water demands

  • Water hardness levels

  • Accessibility of the installation site and the extent of plumbing work required

  • Whether new electrical work is needed

  • The professional hired and any local permit costs

The Truman, MN homeowners’ guide to water softener services

From average costs to expert advice, get all the answers you need to get your job done.