Get matched with top water softener pros in Excelsior, MN

If your water softener repair is fairly straightforward, like a simple filter replacement, then you can probably do it yourself with little risk. However, anything beyond a simple fix should be addressed by someone with extensive plumbing expertise to avoid costly water softener problems, like leaks. 

That said, even simple problems can be complicated to diagnose, particularly if your water softener is attached to a whole-house treatment system. So, unless you feel absolutely certain that the problem is an easy fix that you can take on yourself, it's probably best to hire a plumber to diagnose and fix the problem.

Whether you need a license or permit for water softener installation depends on your location. Some municipalities require the installer to hold a plumbing license, while others may only require a permit and an inspection. In some cases, both a permit and a licensed installer are necessary, and some areas have no requirements at all. Often, only certified plumbers and electricians are allowed to pull the necessary permits. To find out the specific regulations in your area, you can contact your local building department. Alternatively, a local water softener installer or plumber will be familiar with the requirements and can typically pull the permits for you. Regardless of local laws, it is always recommended to hire a licensed professional to ensure the system is sized and installed correctly. You can use tools like Angi’s state licensing tool to verify an installer's license status.

A single shower consumes an average of over 17 gallons, while brushing your teeth with the water running uses up to four unnecessary gallons. Watering the lawn spreads hundreds of gallons of water across the yard each time. Limiting water usage in these areas can significantly cut down your water bill.

You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips. 

The process of inspecting your water softener system is similar.