Get matched with top heating and air conditioning pros in Newton, MA

"Peter and Mark were very professional. I needed to replace the HVAC dampers and the communication with Peter was excellent and we had all questions answered ahead of time so we didnt have any last minute surprises. They showed up on time and installed the dampers and the HVAC control panel. Very thorough and clean with their work. I've already recommended them to my neighbors."

"Great communication and reasonable pricing. Showed up and did the work when they said they would. Had them disconnect and drain an old oil boiler that I needed to remove."

"Joe, the AirCo sales representative, was very professional. He actually asked for my feedback on priorities for a new boiler. This was important to me because the boiler sits below our family room, and the noise level of the boiler was as issue. His proposals listed several boiler options, based on heating efficiency, which were competitively priced. The installation was run by Steve, who was able to fit in the installation the next week. Steve, and his crews, were punctual and courteous, and the installation went smoothly. It's only been a week, but I am very pleased with my Bosch boiler, the quality of the work, the price paid, and the timeliness of the installation."

"The repair went well. Our HVAC system would not turn on so Mike showed up earlier than scheduled (I was called first for the ok) and got right to business. He found the problem- a blow fuse in the unit itself. Once he replaced the fuse the system still would not turn on, but the circuit board that runs the system did light up. he checked out the electrical to make sure there was not a short that caused the problem. It seemed baffling as to the issue so he went outside and checked to see if the electrical issue was at the compressor. Sure enough an animal had chewed thru some of the wiring on the compressor. He spliced the wires together and the system started up, I applaud him for not assuming that the board was faulty and just replacing the board. I would say that Mike did an A+ job troubleshooting to determine what the issue was. The only problem was the cost, and I suppose I should have asked more questions. I asked how much to come out and was told $99 to troubleshoot, but I never asked what other charges apply. Apparently the charge is $99 just to show up and troubleshoot the issue, then $220 per hour is added to that for Mike's time there. I felt $319 was a little steep, but perhaps that is the going rate. I want to emphasize that Mike did an excellent job of solving the issue."

"Ken's HVAC was immediately responsive to my call and came the next day. When we noticed an additional heating issue I called on Sunday and Ken picked up and scheduled to come out on Monday. He did, and we now have heat. Ken was thorough, professional, and explained everything he was doing. I felt very confident in his work."

"Fantastic. In and out in within 2 hours. Cost $15,000 less than another Angie's List HVAC service person quoted me."

"Dodge Cooling and Heating was the only Company that responded to our emergency needs quickly. They were professional, on time and fixed the issue."

"Excellent service would recommend for my next electrical job"

"Chris was prompt and reliable. Came when he said he would. Completed a basic HVAC servicing and cleaning. Left me a report of his work performed. Would recommend."

"Our oil burner cracked and needed to be replaced. The burner heats our water, so we would be without hot water until we replaced the burner. Steve Chamber arrived quickly, provided a competitive quote and got the oil burner installed and our hot water restored within a few days.. The final bill was exactly what was quoted and they cleaned up after themselves, even removing the cardboard boxes. I highly recommend Chamber HVAC and love that it is a family owned and operated business!"