Best garage pros near Bush, LA

Your epoxy garage floors will last two to 10 years, depending on foot traffic and maintenance. Clean your floor regularly with a mop or a power washer using a diluted ammonia or degreaser solution. Use five ounces of ammonia per gallon of water or a half-cup of degreaser per gallon of water.

Also, sweep regularly, clean up any spills right away, and install mats in places where you expect the most foot traffic.

You should spray garage door lubricant on its important mechanical parts, including the hinges, rollers, springs, bearing plates, lock, armbar, and, potentially, rail. Do not lube the tracks, though you should clean these regularly for optimal performance.

As with anything you buy, be wary of prices that seem too good to be true. Some low-cost flooring products can contain chemicals that release harmful VOCs (volatile organic compounds) in the form of fumes that can be inhaled or dust that can cause skin conditions.

Even good-quality products can be dangerous for DIY-ers who don’t take proper precautions. Always carefully read manufacturer instructions and wear the recommended protective gear when working with paints and other chemicals. You can also hire a local garage flooring pro with the experience and equipment needed to perform the installation safely with no lingering fumes or debris.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.