Get matched with top roofers in Benton, KY

Rain shouldn’t come in through your ridge vents unless your vents are damaged or the rain is accompanied by very high winds. Most ridge vents use flashing or baffling to keep out rain, snow, and debris. If your ridge vent isn’t baffled, rain is more likely to enter your attic, so ridge vents with baffles are a better choice in areas with regular rainfall.

A chimney cap costs about $300 on average to install, with prices ranging from $75 to $1,000. The final cost depends on several factors, including the professional you hire, the accessibility of your chimney, the cap's material and size, whether any repairs are needed, and if it requires custom fabrication. Chimney caps are usually made from galvanized steel, stainless steel, or copper. Copper caps are the most expensive, followed by stainless steel and then galvanized steel. Excluding labor, average material costs are around $100 for galvanized steel, $250 for stainless steel, and $600 for copper. You may also face additional costs, such as hiring a chimney sweep to clean the chimney before the cap is installed.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

Chimney crowns are located above the final brick layer at the top of a chimney. It’s important to get regular chimney maintenance and inspection, because it is near impossible to spot chimney crown damage without getting on your roof.