Get matched with top roofers in Kuttawa, KY

Yes, removing a chimney is a difficult and major undertaking. Chimneys often provide structural support to a home, so if it's a load-bearing structure, you'll need to take extra precautions to maintain your home's integrity. A project of this complexity typically requires a structural engineer, a masonry contractor, and a demolition crew. The removal process may involve taking the chimney out brick by brick from inside the walls. The cost for chimney removal can range from $2,000 to $10,000, depending on the job's complexity. Due to the difficulty and cost, some homeowners opt to remove the fireplace and seal the chimney at the top and bottom, sometimes also removing the visible exterior portion at the roofline.

No, there’s no specific building code that requires a roof overhang. However, installing your roof with the standard 2-inch overhang is good practice, as it helps direct runoff away from your fascia boards and roof decking and into your gutters. Some overhang is especially important in areas that see heavy rainfall and snowfall, as the risk of water getting under the roofing material and causing water damage is much higher.

Metal roofs do not inherently leak more than shingle roofs; when properly installed, they are generally less likely to leak. Asphalt shingle roofs are more susceptible to leaks due to factors like wind uplift, damage from extreme weather, moss growth, and ice dams. Over time, asphalt shingles also lose their protective grit, which reduces their waterproofing capabilities. In contrast, metal is a more resilient material that stands up better to heavy precipitation and high winds. However, metal roofs can develop leaks if they are poorly installed, have improperly sealed fasteners, or experience issues from thermal expansion. For this reason, professional installation and regular maintenance are crucial to ensure a metal roof's longevity and superior protection against leaks.

16-gauge galvanized steel staples with a minimum crown of 15/16 inches or 24 millimeters are occasionally used to install shingles. However, most shingle manufacturers or residential building codes don’t recommend staples as a roofing fastener. Roofing nails are preferred in most cases, especially in areas that get a lot of heavy wind.