Get matched with top toilet pros in O Fallon, IL

Yes, you can pour water down the toilet to help it flush. For each flush, you’ll need 1 to 2 gallons of water for newer toilets or 3 to 5 gallons of water for older toilets. Rather than dumping the entire bucket in all at once, pour the water in slowly for the best results. If you’re pouring water down the toilet to help it flush after a clog, only use 1 gallon of hot water.

If you have to hold the toilet handle (also called the toilet lever) down to flush, you probably have a chain problem. A chain that cannot fully lift the flapper will close too early and not clear the toilet bowl. Try adjusting the chain length so there’s about ½ inch of slack.   

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

Even though they’re modern-looking, easier to clean, can be hung at any height, and help save space compared to traditional toilets, wall-hung toilets have some downsides. They’re more expensive than standard toilets, sometimes by a few hundred dollars. They’re also difficult to install and may require major plumbing work to reroute the drain if the previous toilet was a floor-mount model.

This tight fit can make repairs more difficult. You’ll also have to consider where you can hang them and weight limit restrictions, so they may not be the best fit for every home.