Top-rated electricians.

Get matched with top electricians in La Harpe, IL

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in La Harpe, IL?

Select your specific project to find the pro for you.

Find Electricians in La Harpe

Avatar for Neli Virtual Appliance Repair
Neli Virtual Appliance Repair
4.2(
651
)

Serving La Harpe, IL and surrounding areas

Approved

In business since 2016

Free estimates

Warranties offered

"The problem turned out to be a burned out small electric door switch. I believe the price was way too expensive for the service performed and the price of the door switch. What more can I say? It got done."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Response time1 day
2 neighbors recently requested a quote
Recommended by89%of homeowners
Avatar for MW Energy LLC
MW Energy LLC
5.0(
7
)

Serving La Harpe, IL and surrounding areas

In business since 2022

Free estimates

Emergency services offered

"Jimmy is top notch. His quotes are reasonable and honest. Very few contractors I would provide such a glowing review. Hardworking, knowledgable and gets it done. With out hesitation our first choice at anything Electrical."
Panel Replacement
Before Panel Replacement
Response time7 hrs
Response rate89%
Recommended by100%of homeowners
...
Showing 1-10 of 52
Electrical questions, answered by experts

A piggyback circuit breaker, also known as a tandem or double-stuff breaker, combines two separate circuits into a single slot in a breaker panel. This design allows adding more circuits without a larger panel, making it a space-saving solution. Each breaker in the piggyback unit operates independently, protecting two circuits in one standard breaker slot. This is especially useful in older panels with limited space for additional breakers.

Choosing between 12- or 14-gauge wire for your house depends on the electrical requirements of the circuit. A 12-gauge wire is thicker and can handle more power, making it better suited for devices such as kitchen appliances, air conditioning units, or electric heaters.

A 14-gauge wire is thinner and can handle less electrical current than a 12-gauge wire. It's ideal for circuits with lower power requirements, such as lighting or general-purpose outlets in bedrooms or living rooms.

A light switch should be at least 2 inches from the edge of the trim of a door. The location of wall studs will often help determine where to put the light switch by your doorway, and in most cases, wall studs make it impossible to install the switch closer than 2 inches. When possible, try to keep the switch within arm’s length of the entryway.

Tipping an electrician is not a requirement nor is it expected, as they build a fair wage into the price of the job. It’s up to your discretion. There are no set rules for tipping electricians, but if they did a great job and you’re so inclined to tip 10% to 15%, it will likely be received with thanks.

Automatic gates don’t use too much electricity, and you should see a minimal effect on your utility bill. In fact, certain gate systems are entirely self-sufficient and rely on solar panels attached to or near the gate to power the motor. While a gate is large and there is a powerful motor moving it, it’s not something that sees constant use throughout the day. For most automatic gates, expect to see a utility bill increase of only around $10 per month.

The La Harpe, IL homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.