Get matched with top plumbers in Star, ID

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

If your pipes are suddenly making loud noises, it could be due to any of the aforementioned issues. A water hammer is a common cause of this problem. Other potential causes include water pressure issues, loose pipes, air bubbles, and worn-out fixtures. Mineral buildup in the pipes can also cause loud noises. 

A shower cartridge is a component located inside the shower valve. While the terms are sometimes used interchangeably, they are two different parts. The shower valve is the entire device that regulates the flow and temperature of water in your shower. The cartridge is the inner part of the valve that connects to the shower controls, allowing you to adjust the water's temperature and flow by balancing the mix of hot and cold water. While the signs of a failing valve and cartridge can be similar, if you are experiencing issues with water temperature, you may need to replace the entire valve.

Most experienced professionals can get an entire trenchless pipe lining project done in a single day, and smaller projects might take as little as three to four hours. If your technician uses machinery to dig the two access points, the job will likely be faster, whereas manual digging will take a bit longer and could push the project above six hours.