Top-rated above ground pool installation pros.

Best above ground pool installation pros near Salmon, ID

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Salmon, ID?

Select your specific project to find the pro for you.

Top-Rated Above ground pool installation pros in Salmon - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Above Ground Swimming Pool or Accessories - Repair or Service

Serving Salmon, ID and surrounding areas

In business since 1971

Credit card accepted

"One oven doesn't work at all ( my choice, see above), the "working" oven was never calibrated properly so using it is hit or miss. It's time to call American Home Shield to see about replacing the entire unit. I'm waiting to finish other home projects before calling them. I don't know if I'll request Greenway again."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Install Above Ground Pools FAQs, answered by experts

Generally speaking, most municipalities require you to get a permit when you build a pool. Whether or not you need a permit to install a plunge pool will depend on your local laws. It’s always better to check with your HOA and town clerk before digging for a new pool. Otherwise, violations could result in hefty fines. 

Your indoor pool can be heated or unheated, but the decision depends on your local climate. In regions with freezing temperatures, heating your pool will keep it warm during the winter, especially if it’s only covered with a greenhouse enclosure. 

If you keep your swimming water warm and toasty, budget between $300 and $5,700 for the cost of installing a pool heater.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

Generally speaking, you should expect to wait 24 to 48 hours after filling a pool before you use it. However, the actual timeline depends on a few factors. Most importantly, you need to shock the water with chlorine or an alternative to swimming pool chlorine and let the concentration come down to a safe level before using the pool. Additionally, most water sources will be cold, and it can take days before the sun or your pool heater warms your water to a comfortable temperature. Alternatively, getting water professionally delivered could have you swimming in just a few hours.

It’s best to avoid having wrinkles in a new pool liner. Since pool liners are very thin, it’s easy to have slight wrinkles in the liner upon initial installation. This might negatively affect your pool’s visual appearance and lead to tearing and holes in some cases. You’ll want to ensure proper measurements and accurate alignment during the installation process to prevent unsightly wrinkles from appearing.

The Salmon, ID homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.