Get matched with top above ground pool installation pros in Challis, ID

If your pool takes longer than one or two days to fill, you might be dealing with low water pressure. Using a water pressure gauge on your outdoor tap, you can check your water pressure. A reading of 40 psi or below is considered low. A leak, a nearby water shutoff, or several other reasons could cause this. 

If the water pressure isn’t a problem, you could have a low flow rate from clogs, corroded pipes, or other plumbing issues. It’s best to call in a local plumber to get to the root of the issue.

Pool chemical levels should include a pH between 7.4 and 7.6, alkalinity between 80 to 120 ppm, and chlorine from 1 to 3 ppm. The size and type of your pool determine additional chemical levels, such as stabilizers and pool shock, but you can get to know these numbers using our pool maintenance 101 guide.

If you’re wondering how to find a leak in an aboveground pool, the process is the same as it is for an in-ground pool. Note that the vinyl liner in aboveground pools is fairly thin, so sharp objects easily puncture it. Additionally, the liner can wear down after constant exposure to pool chemicals, especially when chlorine levels are higher than they should be. For these reasons, small holes in the vinyl liner often cause leaks, but you can easily detect them with the dye test.

You can install an aboveground pool on various surfaces, including dirt, sand, concrete, and grass. You can’t install a pool on an uneven surface, though, so be sure to level the ground before building your pool. You also can’t install your pool on top of a rocky surface. Three or 4 inches of smooth sand or soil is the ideal surface to go under an aboveground pool.