Get matched with top sump pump installation pros in Runnells, IA

First, you can try unplugging the two sump pump cords, one for the motor and one for the float switch, then plugging them back in to reset the sump pump. You can also reset the sump pump by turning it off and back on at the breaker. Many sump pumps have a reset button, which you can press and hold for a few seconds to reset the device.

A sump pump's lifespan is typically 7 to 10 years, though the general range can be anywhere from 5 to 15 years. The specific type of pump is a major factor: pedestal sump pumps last an average of 20 to 25 years, whereas submersible sump pumps last between 5 and 15 years. While pedestal pumps are less expensive to service, they are also louder and more prone to clogging.

Several other factors influence longevity, including the pump's quality, usage frequency, and maintenance schedule. A high-quality pump that is well-maintained in a dry climate may last for two decades, while a lower-quality, poorly maintained pump in an area with a high water table or frequent flooding may fail in six years or less.

Regular maintenance, including annual inspections and tuneups from a professional, can significantly extend the pump's life. It is time to consider a replacement if your sump pump runs constantly, cycles frequently, shows visible rust or corrosion, or trips a circuit breaker. As a preventative measure, many homeowners replace their pumps every eight years. It's also worth noting that a manufacturer's warranty can indicate expected lifespan, and some home insurance policies may not cover water damage from a pump that is past its recommended replacement date.

You shouldn’t shower while a sump pump isn’t working. Although household wastewater isn’t supposed to go into the sump pit, it’s best to wait to shower until your sump pump is running properly and able to move excess water out of the basement. If you need to shower when the sump pump isn’t working, aim for a short shower.

To maintain your sump pump, start by checking it every three to four months to ensure it’s in working order. Clear any debris from the pit because blockages can prevent the pump from operating efficiently. You should also test the pump by pouring a bucket of water into the pit. If it turns on automatically and drains the water, it’s functioning correctly. Inspect the discharge line for clogs, and ensure it directs water away from your home. Once a year, clean the pump itself, and consider having it professionally serviced for optimal performance.