Get matched with top toilet pros in Holiday, FL

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

Some older homes have toilets in the basement to combat sewage backups. This type of toilet, also known as a Pittsburgh potty, acted as a safety valve over the incoming sewer line. If a line backed up, it would back up into the toilet because it was the lowest fixture in the home, keeping it out of sight and away from the finished areas of the house.

Basement toilets were also used by workers with messy jobs, like those who worked in coal mines or steel mills. This way, they could clean up and avoid tracking dirt through their home.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.