Top-rated toilet pros.

Get matched with top toilet pros in Redmond, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your toilet service project in Redmond, UT?

Select your specific project to find the pro for you.

Find Toilet pros in Redmond

Replumb Specialties Inc.
3.9(
9
)
Faucets, Fixtures and Pipes - Repair or ReplaceFaucets, Fixtures and Pipes - Repair or Replace - For Business

Serving Redmond, UT and surrounding areas

In business since 1992

Free estimates

Warranties offered

"RSI is a great replumb company. The actual replumbing was outstanding and we opted for the upgraded pro-plex fittings to increase our warranty from 10 to 25 years (not an up sell by Jamey - our choice). They also put in-place a dedicated recirculation line for our tankless water heater. The RSI team (Kenny and Milo) was expert at locating and replacing the old polybutylene piping with minimal impact to sheetrock, tiles, and fittings. They finished the work early but were delayed in finalizing the project due to a delay from the Regional Building Inspectors, not RSI's fault. Our only suggestions are 1) better daily clean-up, 2) better attention to detail repainting sheetrock (we had to repeatedly point out areas for a 'redo' and adjacent areas for touch-up) - this seemed harder to do that we expected (this is why we gave them a B rather than an A for quality). Jamey was very responsive to us and answered our questions/concerns thoroughly and promptly. We will recommend RSI our neighbors and friends.
"
Recommended by85%of homeowners
Avatar for Miller Plumbing
Miller Plumbing
0.5(
2
)
Drain Clog or Blockage - Clear

Serving Redmond, UT and surrounding areas

In business since 2016

Free estimates

Offers commercial services

We're dedicated to providing our clients with the very best in service, installation, and repair to meet your plumbing needs. We have 15 years of industry experience. We specialize in mechanical piping and we offer a one year warranty on a variety of residential and commercial services. We take pride in the attention to detail put into each of the projects we're involved with. We're known for our quality work and the integrity of our business. We look forward to building long-term relationships with our clients, and guarantee your satisfaction.

Response time9 hrs
Toilets questions, answered by experts

A running toilet is not a plumbing emergency, but you will want to try some DIY fixes or call in a plumber to prevent wasting gallons of water. The three most common causes of a running toilet are a broken or dirty flapper, an incorrectly sized chain between the flush lever and flapper, or a float that is out of position.

You can DIY your toilet flapper replacement if you’re up for a small plumbing project. Turn off the water to the toilet, open the tank lid, remove the chain from the lever, and unhook the flapper. For a new, adjustable flapper, adjust it to the right setting according to your toilet's gallons per flush rating. Hook the flapper in place and install the chain with 1/2 inch of slack.

Your toilet handle might not come back up if the nut is loose or the bolt threads are stripped. Try to tighten the mounting nut and wrap plumber’s tape around the handle bolt to fix stripped threads. It’s possible the handle was improperly installed. If that’s the case, you can use the instructions above to correct the handle’s position. 

There are a few reasons why this could be the case. More than likely, your flapper is worn out and needs to be replaced. When it’s worn out, it lowers the water pressure during each flush leading to inefficient flushing. Luckily, replacing a toilet flapper is a simple repair that should only take about 30 minutes.

Depending on the issue and materials, costs range from $150 to $500.

The Redmond, UT homeowners’ guide to toilet services

From average costs to expert advice, get all the answers you need to get your job done.