Best toilet pros near Richfield, UT

Some older homes have toilets in the basement to combat sewage backups. This type of toilet, also known as a Pittsburgh potty, acted as a safety valve over the incoming sewer line. If a line backed up, it would back up into the toilet because it was the lowest fixture in the home, keeping it out of sight and away from the finished areas of the house.

Basement toilets were also used by workers with messy jobs, like those who worked in coal mines or steel mills. This way, they could clean up and avoid tracking dirt through their home.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Whether wall-mounted or floor-mounted toilets are better comes down to personal preference.

Overall, standard floor-mount toilets are less expensive to purchase and install, but they don’t offer the streamlined, modern appearance and adjustable height of wall-hung toilets. Ease of cleaning should also be considered, as wall-hung toilets are easier to clean than standard models.

Sealant doesn’t need to be applied to the bolts, but it can be a good way to stop an active leak in the moment. However, don’t rely on it as a cure-all; instead, make sure to fix the problem at the source by changing or tightening the bolts. 

If you do use sealant, make sure to spread it thickly and evenly across the bolts and the tank's porcelain.