Top-rated plaster repair specialists.

Get matched with top plaster repair specialists in Fillmore, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your plaster repair project in Fillmore, UT?

Select your specific project to find the pro for you.

Verified Reviews for Plaster Repair pros in Fillmore, UT

*The Angi rating for Plaster Repair companies in Fillmore, UT is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Plaster Repair needs.

*The HomeAdvisor rating for Plaster Repair companies in Fillmore, UT is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Plaster Repair needs.

Last update on April 23, 2024

Find Plaster repair specialists in Fillmore

Plaster Repair questions, answered by experts

Smaller is better when patching holes with spackle. Any holes wider than four to six inches in diameter tend to be too wide to repair with spackle alone. You'll likely want to patch bigger holes with a drywall panel. 

Even holes measuring up to 6 inches may be challenging to fill with spackle alone. For best results, purchase a wall repair patch made from wire mesh. Cut the patch to fit over the hole, then use the spackle to hold it in place. Apply the spackle over the patch as you would for a smaller hole.

The cost to repair a ceiling after a water leak can vary, with averages ranging from $419 to $1,359, or $45 to $55 per square foot. Smaller patches may cost around $150. The final price depends on the size of the affected area and the extent of the damage. Remember that you will also need to repair the source of the leak, such as roof damage or a plumbing issue, which can cost an additional $200 to $1,550. Depending on the situation, you might also face costs for repainting or repairing floors. For an accurate estimate, it is best to get a quote from a professional.

Yes, you can apply new plaster over an existing plaster surface, such as a wall or ceiling, provided the old plaster is in good condition. Before you begin, check the stability of the existing plaster. The surface must be clean, free of loose material, and have no peeling paint. It is also recommended to roughen the surface slightly to promote adhesion. For older plaster, applying a base coat like a PVA emulsion or a specific bonding agent or primer is crucial. This step makes the existing plaster less porous and ensures the new and old layers adhere properly for a smooth, long-lasting finish.

You’ll want to inspect your plaster walls for signs of damage before painting. If you notice soft spots, deep cracks, bubbling, or areas where the plaster is crumbling or pulling away from the wall, it likely needs repair. While small hairline cracks are common and likely cosmetic, you should address larger issues before painting to ensure a quality, smooth finish.

Only use spackle on plaster walls when the imperfection is small. It’s best used for nail holes or small dings in the plaster. Spackle dries quickly, allowing you to continue the repair process shortly after using it. Plaster can be tricky to repair, though, so if you run into issues, call a pro so that you don’t risk further damage.

The Fillmore, UT homeowners’ guide to plaster repairs

From average costs to expert advice, get all the answers you need to get your job done.

See all articles