Get matched with top drywall pros in Graford, TX

Drywall does not necessarily need to be glued to the ceiling, especially when it is properly screwed or nailed into place. Drywall is typically attached to the ceiling joists using screws or nails, ensuring a secure and stable drywall installation. 

However, in certain situations where additional adhesion is required, construction adhesive can be applied in combination with screws or nails. This is often done for ceilings with specific acoustic or insulation requirements. It's essential to follow local building codes and best practices to determine if adhesive use is necessary for your specific project.

If you’re installing new drywall, you may need to skim coat the drywall first for a smooth finish and to allow the primer to adhere to the wall. It’s only necessary if there are imperfections in your drywall due to issues with the studs or improper drywall installation. If you’re refreshing existing walls, you may want to skim coat if there are imperfections across the wall. As an alternative, you can repair your drywall and sand it for a smooth finish before painting.

For maximum stability, install grab bars on wall studs, as this will adequately support the weight. However, if you don't have access to studs, you can get by with wall anchors. If opting for the latter, choose specialty hollow wall anchors. 

The best way to make long, straight cuts is to use a utility knife and a T-square to score the sheet, snap along the score, and then finish the cut by cutting through the paper on the opposite side with the utility knife. If you’re making small cuts, curved cuts, or cutouts for electrical boxes or light fixtures, you can use a manual jab saw to keep costs down, but an electric spiral saw or oscillating multi-tool will get the cleanest, fastest cuts possible.