Get matched with top electricians in John Day, OR

Q: How do I know if my microwave fuse is blown?

• <div><p>If your microwave is on the fritz and you suspect the fuse has blown, you can check it to confirm it&rsquo;s the source of the problem. Start by disassembling the panel and carefully checking the fuse filament or ceramic components. If your microwave uses a glass fuse, you&rsquo;ll likely see discoloration and a melted filament. If your microwave contains a ceramic fuse, you&rsquo;ll need to use a multimeter continuity tester to check if there&rsquo;s continuity.</p></div>

Q: How close can an electrical outlet be to a sink?

• <div><p>The NEC requires electrical outlets be installed in a kitchen that has a sink 12 inches wide and 24 inches deep. According to the code, that outlet must be within 2 feet of the kitchen sink. Bathrooms must have at least one electrical outlet, it must be GFCI, and it must be within 3 feet of the bathroom sink.</p></div>

Q: How many times can a breaker trip before it needs to be replaced?

• <div><p>While circuit breakers are designed to be reset after tripping, there isn't a strict countdown to when they will fail. The primary danger lies in a breaker tripping multiple times in a short period without allowing the components to cool down. Theoretically, a standard breaker might handle around 50 trips caused by simple overloading. However, this number can be much lower in practice. For instance, a high-current fault could damage a breaker to the point that it needs replacement after only two resets. Repeatedly resetting a breaker that trips frequently exacerbates the underlying problem by causing the electrical components, wires, and the breaker itself to overheat. This can lead to permanent damage, cause the breaker to trip unnecessarily in the future, and increase the risk of an electrical fire. If a breaker trips every few minutes, you should leave it in the 'off' position and call a qualified electrician for an inspection.</p></div>

Q: When wiring your box how much wire should you leave in the box?

• <div><p>The National Electrical Codebook indicates that there should be at least 6 inches of wiring in the breaker box for connecting purposes. When in doubt, err on the side more, because you can always cut some wire off but you can never add it back on, and if you don&rsquo;t have enough you may struggle to finish wiring your breaker box properly.</p></div>

Q: Does using a dimmer switch affect ceiling fan performance?

• <div><p>Yes, standard dimmer switches should never be used to control a ceiling fan motor. They&rsquo;re designed for lighting, not motors, and they can cause humming, overheating, or permanent damage. You should only use switches that are specifically labeled for fan speed control.</p></div>

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in John Day, OR?

Select your specific project to find the pro for you.

Verified Reviews for Electrical Service pros in John Day, OR

*The Angi rating for Electrical Service companies in John Day, OR is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Electrical Service needs.

*The HomeAdvisor rating for Electrical Service companies in John Day, OR is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Electrical Service needs.

Last update on May 23, 2026

Reviewed in May 2026
John Martin and his team have done great work for us. They have done several projects for us ( Shadow Box fence for our backyard, Extension wall for our staircase, capped the under side of our front porch/deck, and a few other things. John always answers his calls or returns messages asap and...
Superior Home Builders Corp
Request a quote
Reviewed in October 2025
The installers, Bill Sevey, Mike Clark and Caleb Schmitt, were friendly, efficient, professional and knowledgeable. They took care to be neat and everything was cleaned up when they left. We are very happy with our new windows!
Renewal by Andersen of Boise
Request a quote
Reviewed in September 2023
The owner is easy to work with, very informative and knowledgeable about products. Products are great quality.
Prodigy Fence Co.
Request a quote
Reviewed in May 2023
We recently had 10 windows replaced on our 112 year old schoolhouse. These windows were the originals. From the first visit to the finish we have been extremely pleased. Mark explained the construction, features, time line and benefits with amazing detail. The office personnel were helpful and...
Renewal by Andersen of Washington
Request a quote
Reviewed in December 2022
Bruce was professional, courteous and most importantly, thorough and very responsive.
BK Home Inspections
Request a quote
Reviewed in January 2021
Our house looks really nice.
Matthew John McGinty
Request a quote
Reviewed in August 2018
Called and they came, gave an estimate and we're right on time for the job. Went above and beyond. Great team.
Palms Tree Service and Landscaping
Request a quote
Reviewed in February 2013
He was there when he said he would be. Was quick and professional. <br />
D WOLF ELECTRIC
Request a quote
Reviewed in July 2005
WE HAVE BEEN VERY HAPPY WITH THE WORK THAT RED'S ELECTRIC HAS PROVIDED FOR US ON SEVERAL OCCASIONS. THE WORK THAT HAS BEEN INVOLVED IN OUR PROJECTS HAS SOMETIMES BEEN COMPLEX, BUT THEY KNOW WHAT THEY ARE DOING AND WE ARE PLEASED WITH THE SERVICES THAT THEY HAVE PROVIDED.
RED'S ELECTRICAL SERVICE
Request a quote

Find Electricians in John Day

My Computer Works, Inc.

4.0(

630

)

Serving John Day, OR and surrounding areas

In business since 2005

Free estimates

Credit card accepted

"Bob made sure work was done.Steve computer tech was outstanding."

Recommended by86%of homeowners

Serving John Day, OR and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Found and replaced a broken electrical switch."

Recommended by82%of homeowners

Request Quote

American Home Shield – Home Warranty

3.5(

5,688

)

Serving John Day, OR and surrounding areas

In business since 1971

Credit card accepted

"We have American Home Shield warranty. We did have some plumbing and electrical work done. I have no idea who the service was because we did it through the home warranty. They have a $75 deductible for everything. American Home Shield has been great, definitely A across the board. The $75 deductible seemed great for cost and professionalism. They have a web site, Hub, where you can request service and everything, so A across the board for them. They are punctual and they cover the range of plumbing and - they cover a lot of issues with the home so I can always go to them if anything goes wrong, from plumbing to electrical to appliances. They've got me covered across the board."

Recommended by65%of homeowners

Serving John Day, OR and surrounding areas

In business since 2020

Emergency services offered

Credit card accepted

"There were many things wrong in my computer (my fault and letting grandchildren on computer) Robert was so helpful, gave me many good instructions to keep everything safe, which I have written down, feel like I have a new computer. He was so excellent and experienced, took his time and was meticulous about what needed to be done. He was a pleasure to work with and I will use this company again! Linda Disy"

Helping a Victim who was being Cyber-stocked

Recommended by91%of homeowners

Request Quote

JBC Group Solutions Inc

4.0(

)

Serving John Day, OR and surrounding areas

In business since 2007

Emergency services offered

1-888-JBC-ON-TIME (888-522-6684). 26 employees in Portland area. No subs used. Payment may be made via PayPal.

Recommended by75%of homeowners

Request Quote

TechDrive Support Inc

New to Angi

Serving John Day, OR and surrounding areas

In business since 2022

Free estimates

Credit card accepted

TechDrive Support is a tech company that provides customer support for any issues pertaining to your computer, printer & other devices. We offers industry-leading remote technical support for software and hardware issues. We aim to simplify technology by providing end-to-end technical customer support and solutions for all your gadgets. Our Tech Advisors can remotely assist you in setting up a new computer or printer, upgrading or restoring your software and operating system, diagnosing hardware issues, and much more.\n\n24*7 remote support\nQuick resolutions\nAffordable prices\n100% customer satisfaction

Request Quote

Electrical questions, answered by experts

If your microwave is on the fritz and you suspect the fuse has blown, you can check it to confirm it’s the source of the problem. Start by disassembling the panel and carefully checking the fuse filament or ceramic components. If your microwave uses a glass fuse, you’ll likely see discoloration and a melted filament. If your microwave contains a ceramic fuse, you’ll need to use a multimeter continuity tester to check if there’s continuity.

The NEC requires electrical outlets be installed in a kitchen that has a sink 12 inches wide and 24 inches deep. According to the code, that outlet must be within 2 feet of the kitchen sink. Bathrooms must have at least one electrical outlet, it must be GFCI, and it must be within 3 feet of the bathroom sink.

While circuit breakers are designed to be reset after tripping, there isn't a strict countdown to when they will fail. The primary danger lies in a breaker tripping multiple times in a short period without allowing the components to cool down. Theoretically, a standard breaker might handle around 50 trips caused by simple overloading. However, this number can be much lower in practice. For instance, a high-current fault could damage a breaker to the point that it needs replacement after only two resets. Repeatedly resetting a breaker that trips frequently exacerbates the underlying problem by causing the electrical components, wires, and the breaker itself to overheat. This can lead to permanent damage, cause the breaker to trip unnecessarily in the future, and increase the risk of an electrical fire. If a breaker trips every few minutes, you should leave it in the 'off' position and call a qualified electrician for an inspection.

The National Electrical Codebook indicates that there should be at least 6 inches of wiring in the breaker box for connecting purposes. When in doubt, err on the side more, because you can always cut some wire off but you can never add it back on, and if you don’t have enough you may struggle to finish wiring your breaker box properly.

Yes, standard dimmer switches should never be used to control a ceiling fan motor. They’re designed for lighting, not motors, and they can cause humming, overheating, or permanent damage. You should only use switches that are specifically labeled for fan speed control.

The John Day, OR homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles

Breyden Kellam
•
Apr 6, 2026Apr 6, 2026
How Much Does It Cost to Run Electric from the Road to Your House? [2026 Data]
Before you hire a licensed electrical contractor, you should learn the cost to run electric from the road to your house so you can budget for the project.
Deane Biermeier
•
Apr 6, 2026Apr 6, 2026
Electrical Outlet Repair Cost [2026 Cost Data]
Discover the electrical outlet repair cost of different outlet types depending on the problem, location, amperage, and other factors.
Catherine Hiles
•
Apr 6, 2026Apr 6, 2026
How Much Does Moving an Electric Meter Cost? [2026 Data]
The cost to move an electric meter depends on how far you’re moving it, whether it needs replacing, and the cost of labor near you.
Lawrence Bonk
•
May 2, 2026May 2, 2026
Types of Electrical Boxes and How To Pick the Best One
Electrical boxes are a crucial part of your home’s electrical system, but it can be challenging to wrap your head around the various shapes, sizes, and types available. Keep reading to learn about the different types of electrical boxes and their uses.
Margaret Wack
•
Apr 8, 2026Apr 8, 2026
8 Types of Electrical Wires You Can Find in Your Home
Nearly every electrical wire in your home has a different purpose. This article will cover the types of electrical wires, what they’re for, and how you can tell them apart.
C.E. Larusso
•
May 3, 2026May 3, 2026
What Is an Electrical Inspection and When Do You Need One?
Learn about the red flags that signal it’s time to get an electrical inspection, what it will cover, and what issues can fail these important safety checks.