Best siding pros near London, OH

Wood siding requires an air gap behind it to allow water to drain out, and for air circulation and venting to allow humid air to escape and keep the material from rotting due to moisture. 

The recommended PSI (pounds per square inch) for cleaning vinyl siding can vary, so it's best to consult the manufacturer's guidelines. Generally, vinyl siding can handle high pressure, from 2,500 to 3,500 PSI. For comparison, more delicate materials like wood and aluminum siding should not face more than 1,500 PSI. To safely disperse the pressure on vinyl, use a tip with a wider spray span, such as a green (25-degree) or yellow (15-degree) nozzle. For routine cleaning of light dirt, a garden hose with a spray nozzle may be sufficient. Always exercise caution to avoid using excessive pressure that could damage the siding.

You should plan to stain or refinish your home's cedar siding every three to seven years to maintain its appearance and provide maximum protection, though some estimates suggest a range of four to six years. The exact frequency depends on several factors, including your local climate, exposure to severe weather like direct sunlight, rain, and wind, the quality of the initial stain application, the type of stain used, and the overall condition and quality of the wood.

For homes in harsh climates with high humidity and significant sun exposure, you should plan on staining as often as every three years, while those in milder locations may only need to do so every seven years. For the longest-lasting protection in particularly harsh climates, consider using an opaque stain.

If you are looking for a lower-maintenance alternative, you might consider vinyl or aluminum siding. While the initial installation cost can be higher, they do not require as much upkeep and can offer more value over time, especially in areas with excessive rainfall or high humidity.

To calculate how much siding you need for exterior walls, first measure the height and width of the rectangular walls. For the triangular gable walls, measure the width and then the height from the ground to the tallest gable point.

• For the rectangular walls, the calculation is: length x height

• For the triangular gable walls, the calculation is: (length x height) / 2

Once you add these up, include an additional 10% to account for any wastage.