Get matched with top affordable plumbers in Continental, OH

A standard toilet flange should fit snugly into the outflow pipe and sit level with the subfloor. Installing a new one without first removing the old one will make it impossible to form a seal and keep the toilet bowl bolted securely in place. 

However, if you’re dealing with leakage or wobbling because you’ve installed a new type of bathroom tile (making the floor taller), you may be able to avoid fully replacing the flange by opting for a toilet flange extender. Extenders typically come in kits for easy DIY installation, fit over the existing flange, and bring the drain connection higher.

The average cost to replace a toilet fill valve is around $100, and prices range from $50 up to $150, depending on your location, the experience of the plumber, and how accessible your toilet is. In most cases, a professional plumber can replace your fill valve in under an hour, although it might take longer if they also need to fix or replace other components at the same time.

You might need a permit to modify or repair any portion of your plumbing system, including drainage lines, depending on where you live. In some areas, simple replacements of existing drain lines don’t require a permit. We recommend asking your drain pipe installer or your local building department about permitting requirements. In many cases, only certified plumbers can pull plumbing permits, so you’ll usually need to leave the permit application to your professional. The fee for the permit will be passed to you on your project bill, though.

Dripping misters are a sign that the nozzles or holes in the tubing have some problems. Try flushing your system thoroughly. If that doesn’t help, examine each nozzle closely and clean them thoroughly with a brush, making sure the exit points are as smooth as possible. If this still doesn’t work, you may need to take off the nozzles entirely and soak them in water with a cleaning solution for a while. This is an important step if dust, mildew, or other gunk builds up in the nozzles.