Get matched with top affordable plumbers in Hamler, OH

While plumber’s tape is a great solution for many plumbing problems, there are some times when it’s not the right product for the job at hand. 

You shouldn’t use plumber’s tape on pipe connections in any of the following scenarios:

• When connecting PVC pipes

• If the pipe has wide threads, as water can still leak through the space between the threads

• If the pipe has very tight threads, as the tape would prevent a proper connection

• If the pipe threads are damaged, which would prevent the tape from providing a watertight seal

If your predicament is similar to any of these, a licensed plumber can help you solve the problem.

No, a larger well pressure tank will not increase your home's water pressure by itself. Water pressure is determined by the pressure control switch on the well pump.

However, a larger tank does offer other benefits. It can store more water, which allows you to run water for longer periods before the pump needs to turn on. This reduces how often the pump cycles on and off, leading to less wear and tear on the pump and the entire well system. Consequently, a larger tank can help extend the life of your equipment and may prevent future pump issues that could affect water pressure.

If your goal is to increase water pressure, consider these alternatives:

• Adjust the pressure settings on your tank to a higher PSI (pounds per square inch).

• Replace your current pump with a model that has a higher flow rate, measured in gallons per minute (GPM).

• Have a professional install a water pressure booster pump in your plumbing system.

• If you experience pressure fluctuations, consider upgrading to a constant pressure system.

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.

You generally cannot replace a 10-inch rough-in toilet with a 12-inch model without making significant plumbing updates. A 12-inch rough-in toilet will not fit a 10-inch rough-in space because the floor drain is in the wrong position. To accommodate the larger toilet, you would need to move the drainpipe, which could cost between $0.75 and $30 per linear foot, plus labor. In most cases, it is more cost-effective and simpler to purchase a new 10-inch rough-in toilet. However, it is possible to install a 10-inch rough-in toilet in a 12-inch space by using a longer connector.