Top-rated electricians.

Get matched with top electricians in Zia Pueblo, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Zia Pueblo, NM?

Select your specific project to find the pro for you.

Find Electricians in Zia Pueblo

DC Ltd. Co.
4.8(
5
)
Electrical Switches, Outlets & Fixtures - Install or RepairElectrical Wiring or Panel UpgradeElectrical for Home Addition or Remodel - Install+2 more

Serving Zia Pueblo, NM and surrounding areas

Approved

Emergency services offered

Warranties offered

Small jobs welcome

"DC LLC/Chris McDaniel did an outstanding job for NNMC's El Rito Campus. They pulled electricity to our greenhouse and installed irrigation systems at both the greenhouse and our rain gardens. From start to finish, their work was top-notch ? knowledgeable, professional, and thorough. What really set them apart was how well they worked with our facilities team and how they kept communication open throughout the entire project. Chris genuinely cares about the quality of his work and it shows. They were helpful, responsive, and a pleasure to work with. Highly recommend DC LLC for anyone looking for a reliable, skilled contractor. We couldn't have asked for a better experience."
21 neighbors recently requested a quote
Albuquerque Plumbing Heating & Cooling, Inc.
4.2(
142
)
Electrical Switches, Outlets & Fixtures - Install or RepairElectrical Wiring or Panel UpgradeElectric Vehicle Charging Station Installation - Materials Provided by Consumer+6 more

Serving Zia Pueblo, NM and surrounding areas

Approved

In business since 2016

Free estimates

Credit card accepted

"Albuquerque Plumbing was prompt, fully described recommended system, was fully responsive to our desires regarding electrical wiring and drainage locations. Crew arrived on promised date and installation went smoothly. Slight glitch regarding mistakenly not completely turning tankless water heater back on was immediately addressed by installation crew when notified. System functioning as advertised. Very pleased with Humidifier. Hope to have successful relationship with Albuquerque Plumbing in future."
Response time3 hrs
44 neighbors recently requested a quote
Recommended by91%of homeowners
...
Showing 1-10 of 115
Electrical questions, answered by experts

If you find the power cables for your appliances are too short, there are ways to extend them for the cost of just the extra wiring you need. Simply cut and strip your wires, solder them together, and cover them using heat shrink tubing. Not everyone has a soldering tool on hand, so if you’re looking to extend in a pinch, an extension cord, power bar, or surge protector can do the job just fine.

A light switch should be at least 2 inches from the edge of the trim of a door. The location of wall studs will often help determine where to put the light switch by your doorway, and in most cases, wall studs make it impossible to install the switch closer than 2 inches. When possible, try to keep the switch within arm’s length of the entryway.

It's recommended that you only use your circuit breaker for your water heater. Tacking on additional appliances, especially large ones like refrigerators, can overload the circuit and lead to electrical fires. Therefore, it's best to have separate circuits for each major appliance, particularly continuous load appliances, which use a lot of energy over prolonged periods of time.

By nature, two-prong outlets aren't grounded—but the box they run to might be, which makes them safer. The safest way to test if an outlet is grounded is to purchase a circuit tester, which cost about $20 at home improvement stores. 

If you discover your outlet (or outlets) aren't grounded, know that this greatly increases your risk of personal injury and electrical fires. You may want to consider installing new three-prong ground fault circuit interrupter (GFCI) outlets. On average, the cost to install GFCI outlets is about $210 per outlet.

Some portable cooktops are compatible with standard 120-volt outlets, but most induction (and electric) ranges and stoves need a dedicated 220- or 240-volt circuit and 40 to 50 amps to work. If you are replacing an old electric range with an induction one, you likely already have the proper outlet, but it’s worth checking with a local appliance installation company.

The Zia Pueblo, NM homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.