Get matched with top concrete resurfacing pros in Espanola, NM

The average cost to repair a concrete driveway ranges from approximately $830 to $2,800, with a typical project costing around $1,765. The price varies widely depending on the type and extent of the damage. Minor crack repairs can be as low as $0.10 to $0.15 per linear foot and may be a DIY project. More significant repairs are priced per square foot: replacing a damaged slab costs about $6 to $14, while raising or leveling sunken concrete costs $3 to $25. Resurfacing is another option, costing around $3 to $5 per square foot. Factors influencing the total price include the size of the affected area, whether reinforcement is needed, and labor costs.

If the cracks in your concrete patio are cosmetic, you can pour a concrete overlay over the patio to cover them up. However, you shouldn’t cover more severe cracks because the underlying damage will simply cause new cracks to appear in the overlay. Patio repair costs $750 to $2,500, depending on the type of repairs and the extent of the damage.

Yes, adding a patio or other concrete feature can increase your property taxes, particularly if it's considered a permanent improvement. The general rule is that if the project requires a permit, your property taxes will likely go up.

Permanent structures like a poured concrete patio are considered capital improvements that require a permit, which will trigger a reassessment of your property's value. Other concrete projects that typically increase taxes include:

• Pool decks

• Walkways

• Driveways

• Steps

• Foundations

In contrast, 'temporary' installations, such as a paver or flagstone patio, may not require a permit and are less likely to affect your property taxes.

Permit costs for a concrete patio can range from $75 to $200. While the tax increase varies based on your location and the project's size, it is often a minimal amount. Always contact your local building department before starting a project to confirm permit requirements and any potential impact on your taxes.

Concrete resurfacing and concrete overlay are terms often used interchangeably to describe the process of applying a new, thin layer of pre-blended concrete over an existing slab. This process enhances the durability and appearance of the concrete, giving it a fresh look without the high cost of a full replacement. The new layer is typically between 1/4-inch and 1-inch thick, significantly less than the 4 inches required for a new slab, and can be stamped, colored, or textured for a custom finish.

While the terms are often considered the same, their meaning can sometimes vary by contractor. Some may use "overlay" to describe a thicker application that adds structural integrity, while "resurfacing" might refer to a thinner layer intended for cosmetic upgrades. Other common names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.