Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Clovis, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Clovis, NM?

Select your specific project to find the pro for you.

Find Epoxy flooring pros in Clovis

Avatar for Mammoth Coatings
Mammoth Coatings
4.2(
5
)
Concrete Floor Coating-Apply - For Business

Serving Clovis, NM and surrounding areas

In business since 2018

Free estimates

Credit card accepted

"I hired this company to resurface my 3 car garage. I was shocked to find I could have a glossy design for my budget... instead of just having my concrete fixed up. Thank you Mammoth!"
Einstein Bros Bagels
Chips
Garage Floor with Chips
Chips
Joint Fill

+6

Response time2 days
Response rate89%
Recommended by100%of homeowners
Avatar for Villanueva Concrete
Villanueva Concrete
5.0(
4
)
Concrete Finishing, Overlays & Coloring - Apply

Serving Clovis, NM and surrounding areas

In business since 2017

Free estimates

Emergency services offered

"A very good experience. Dominic and his crew worked on this project until we and they were satisfied. They went above and beyond. We have already recommended them and will definitely keep them in mind for future projects."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+17

Response time2 days
Response rate100%
Recommended by100%of homeowners
Showing 1-10 of 13
Epoxy Flooring questions, answered by experts

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

You can whiten concrete for unsealed and unfinished concrete with a solution or either muriatic acid or bleach and water—but never both. However, if your concrete does have a stain, finish, or polish, keep in mind that these hard chemicals could damage the topcoat. Your best bet otherwise is to power wash outdoor concrete slabs or clean indoor ones with a gentle cleaner such as laundry or dish detergent.

Polished concrete gets its glass-like finish from several rounds of polishing, using increasingly finer grit diamond grinding pads. The concrete’s hardness will determine which grits you need to get your desired finish. The densifier and sealer also contribute to the look of the final floor, so either talk to a concrete pro (or hire one) to achieve the right concrete floor finish.

Installation typically takes 2-5 days, including preparation, pouring, and curing time.

Epoxy coatings for garage floors offer a variety of finish and design options, including:

  • Decorative colored flakes: $10 per 250-pound bag

  • Metallic epoxy: $5–$12 per square foot

  • Rock or stone epoxy: $100 per gallon

  • Acrylic and poly-acrylic sealants: $0.85–$1.15 per square foot

  • Polyurethane sealant: $0.95–$1.10 per square foot

  • Polyurea sealant: $150 per gallon

The Clovis, NM homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.