Get matched with top epoxy flooring pros in Dimmitt, TX

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.

New flooring costs quite a bit, so longevity is important to think about. Concrete generally has the longest life span, but it’s not always a good solution for homes with wooden subfloors. That said, hardwood floors and stone floors can last up to 100 years, and you can refinish or restore them to remove imperfections from daily wear.

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.

Garage floor sealers last anywhere from one to 10 years on average, depending on the type of sealer you use and the traffic it’s exposed to. Acrylic sealers have the shortest longevity, whereas most other options can last anywhere from five to 10 years. If you use an acrylic sealant to protect against stains, reapply every one to two years. Reapply other types of concrete sealers every five years for the best results and maximum protection.