Best toilet pros near Mead, NE

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Yes, you can install a basement bathroom without breaking concrete by using an upflush toilet system, which includes a macerator pump. These systems sit on top of the concrete floor, so you don't have to drill into it to install plumbing. The macerator pump breaks up waste until it is soft enough to pass through a discharge pipe to the main sewage line. This method saves you time and money by bypassing the need to break concrete to connect drain pipes.

Even though they’re modern-looking, easier to clean, can be hung at any height, and help save space compared to traditional toilets, wall-hung toilets have some downsides. They’re more expensive than standard toilets, sometimes by a few hundred dollars. They’re also difficult to install and may require major plumbing work to reroute the drain if the previous toilet was a floor-mount model.

This tight fit can make repairs more difficult. You’ll also have to consider where you can hang them and weight limit restrictions, so they may not be the best fit for every home.

No, your toilet tank should not empty completely when you flush. Although the water level will dip a lot after you flush, it shouldn’t be totally empty. If your tank is empty, you might have issues with your fill valve, float ball, or toilet trip lever. You should check all of your toilet parts to ensure they’re working correctly and make any necessary adjustments.