Get matched with top pool table assembly pros in Belews Creek, NC

Installing an infinity pool takes up to 12 weeks. It can take as long as 20 weeks if you have a complex design, are building a pool in an inaccessible area, or face weather-related construction delays. Either way, this is a big job that requires a lot of time and labor to get it right. Pool construction is not a job that should be rushed, as poor installation can lead to expensive recurring repair costs. 

You can spend less time and money on plunge pool maintenance since they are smaller than standard pools. These pools are easier to clean and maintain yourself than a swimming pool. But like any pool, you’ll need to clean the pool walls and floor, balance the chemicals, check the electrical equipment, make necessary repairs, etc.

Generally, you should run your pool pump for eight to 12 hours a day to keep your water clean and chemical levels balanced. The ideal runtime can vary depending on your specific pump type. While running the pump as much as possible is ideal for cleanliness, it can increase electricity costs. To save money, you can run the pump strategically during non-peak hours when electricity is cheaper, which is often in the evenings or at night. The hours do not need to be consecutive.

An easy way to know whether your sand filter has enough sand is to check how full the filter is and what the sand looks and feels like. The filter container should be two-thirds to three-quarters full of sand. Look for interior marks indicating the ideal sand level. If you put your hand into the sand, it should flow through your fingers without clumping. The filter pressure gauge is also an easy indicator—the right amount of sand leads to normal pressure, while too much or too little sand can cause high or low pressure.