Get matched with top electricians in Fort Harrison, MT

An average, 400-square-foot electric heated driveways consume approximately $3 per hour in terms of electricity. The price may slightly fluctuate depending on your local energy cost. A simple formula to calculate your heated driveway’s total wattage consumption is by multiplying the square footage by 50 watts and then dividing it by 1,000 to get the kilowatt number. Multiply that with your local energy cost per hour and there you have the hourly operating cost.

Yes, GFCI breakers are required for all outdoor outlets. This code requirement applies to all outlets located on balconies, decks, patios, and other outdoor lounge spaces. In addition, outdoor outlets need to have watertight covers that provide protection when cords are plugged in. If you have an older home that may not be up to code, it's a good idea to also ask your electrician about adding GFCIs to some indoor areas. Kitchens, bathrooms, basements, and any other areas of a home that are commonly exposed to moisture should have GCFI breakers.

Most LED bulbs have a plastic covering, while incandescent bulbs will be made from glass. This is because LED bulbs don’t produce as much heat as incandescent bulbs, so the covering doesn’t need to be as heat resistant. Also, an LED light bulb will usually have a marking on its base that identifies it as an LED.

Usually, a light switch goes bad due to normal wear and tear. Light switches are mechanical devices with internal moving parts. These parts make contact with each other, and, over time, the friction can wear them down, causing the switch to feel loose, arc, or fail to operate.