Get matched with top septic tank pros in Fort Harrison, MT

To keep your septic tank healthy, be careful of what you flush and be conservative with water usage, as even flushing too much water down the drain can throw off the septic system’s delicate balance. Never flush anything but human waste and toilet paper down your toilet, and be sure to have the tank inspected and pumped every two to five years, depending on the size of your household and your water usage.

A septic tank riser features a base ring that you need to install flush to the opening of the septic tank. After thoroughly cleaning the opening of the tank, fit the base ring over the opening and use a butyl sealant rope to create an airtight seal with the tank’s rim. Cut the riser rings to the appropriate height and stack them on the base ring. Then, install the riser lid. This task might be taken on by an experienced DIYer, but you should always call a septic tank professional if you are unsure of your skills.

Bladder and diaphragm well pressure tanks are usually pre-charged at the factory. Even so, it’s important to check the air pressure in the tank using a tire pressure gauge on the relief valve. The instruction manual usually calls for 28 psi. Use a hand pump to add more air or release some air from the tank to reach the desired number. Check the pressure periodically to see if you need to add more air to the tank.

With regular servicing, a well pump usually lasts between eight and 15 years. Variables include level of usage, frequency of servicing, and pump quality. You may also be able to hire a local well pump repair service to fix your pump rather than replace it. 

However, often the cost to fix significant problems is as much as or greater than replacing the damaged pump with a new one.