Get matched with top doorbell installation pros in Saint John, MO

Ensures uniform application and maximizes insulation effectiveness and energy savings.

R-30 insulation is better for higher thermal resistance, but whether it’s "better" depends on the application. R-30 is much thicker and suited for areas like attics or floors in cold climates, where more insulation is required. R-13, on the other hand, is thinner and works well for 2x4 walls or milder climates where less insulation is sufficient. Choosing between R-13 and R-30 depends on the area being insulated and the climate. For example, R-30 provides more insulation but may not fit everywhere in your home.

You do not always need to remove old insulation before adding new. If the existing insulation is in good condition—not wet, physically damaged, moldy, or infested with pests—you can add new insulation directly on top of it for a compounding effect. You can also mix different types, such as adding blown-in insulation around existing fiberglass batts.

However, removal is recommended if the old insulation is compromised by water damage or pests. You should also remove it if you plan to install a different type of insulation, like switching from roll or batt insulation to spray foam. If the existing insulation is very old or damaged, you will likely get more benefit from removing it and starting fresh.

Insulating an unheated garage can still be worth it. For instance, insulating an attached garage can help with heat loss from your house in general, and it can also make it easier to store electronics in your garage without worrying about them being exposed to extreme temperatures.

If you use your detached garage as a workspace, insulation can still make a difference. Plus, you can use space heaters and a window unit AC to help condition the space while you work without installing heating.