Top-rated septic tank pros.

Best septic tank pros near Adrian, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your septic tank service project in Adrian, MN?

Select your specific project to find the pro for you.

Top-Rated Septic tank pros in Adrian - Updated Nov 2026

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Septic System - Install or ReplaceSeptic System - Install or Replace - For BusinessSeptic System - Repair+3 more

Serving Adrian, MN and surrounding areas

In business since 1971

Credit card accepted

"The technician emptied the freezer, which was in the basement, to work on the part that needed repair. Then he neglected to put anything back into the freezer, including a turkey I had bought for Christmas and a rack of ribs. Two days after he left, I went out of town for two weeks. The turkey actually exploded and spewed its liquid all over everything, which had to be discarded. I let AHS know and they couldn't even bother to call me or follow up on this. I'm considering not renewing my contract with them because of the quality (or lack thereof) of many of the providers they send."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Septic Tanks FAQs, answered by experts

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

A gurgling toilet usually doesn’t mean that your septic tank is full. If waste can’t drain into a full septic tank, you’ll see water and sewage backing up into your fixtures, but the air that causes gurgling is a result of poor venting. You are more likely to have a clog in your vent stack or a damaged air admittance valve.

The cost of sump pump installation varies depending on factors like the type of sump pump, labor rates, and the complexity of the installation. On average, you can expect to pay around $1,200 for a standard sump pump install. However, the cost may be higher if additional features like a backup system or extensive drainage work are required.

Bladder and diaphragm well pressure tanks are usually pre-charged at the factory. Even so, it’s important to check the air pressure in the tank using a tire pressure gauge on the relief valve. The instruction manual usually calls for 28 psi. Use a hand pump to add more air or release some air from the tank to reach the desired number. Check the pressure periodically to see if you need to add more air to the tank.

Several signs can indicate a faulty well pump pressure switch. These include your pump running continuously, the pump not turning on at all, or a sudden and complete loss of water. Other symptoms are weak water pressure or an erratic, unpredictable water flow from your fixtures. If you notice these issues, the pressure switch may be the cause. Testing the switch can help diagnose the problem. A faulty switch will likely need to be repaired or replaced. If the issue is more complex, it's best to consult a professional well technician to ensure your water supply is restored correctly.

The Adrian, MN homeowners’ guide to septic tank services

From average costs to expert advice, get all the answers you need to get your job done.