Get matched with top sink repair pros in Romulus, MI

Most faucets come with a rubber or plastic gasket that prevents leaks—but that’s not always the case. If your faucet doesn’t come with a gasket or it’s leaking, use a caulk gun to seal the gaps and prevent water damage.

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

The standard kitchen sink size is typically 22 inches by 30 inches. However, kitchen sinks are available in a wide range of sizes to fit different kitchens, commonly from 25 to 39 inches long, though you can find even larger or custom sizes. When choosing a replacement, the easiest option is to select a sink that matches your existing one's dimensions. If you decide to install a larger sink, you will need to enlarge the cutout in your countertop; be sure to use the template that comes with the new sink to ensure a proper fit. Installing a smaller sink can be more complex, as it may require replacing the entire countertop.

Different plumbing problems can cause your P-trap to leak. The biggest problems are loose nuts and misaligned pipes. Over time, your P-trap can leak due to the rush of water moving through the pipes, which in turn loosens the nuts and causes the pipes to fall out of alignment. Other problems include worn rubber O-rings and cracked pipes.