Top-rated drywall insulation pros.

Get matched with top drywall insulation pros in Adamstown, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your drywall insulation project in Adamstown, MD?

Select your specific project to find the pro for you.

TRUSTED BY ADAMSTOWN, MD HOMEOWNERS

  • Average homeowner rating star icon4.7
    Average homeowner rating
  • Verified reviews icon145
    Verified drywall insulation services reviews

Find Drywall insulation pros in Adamstown

Avatar for Atlas Home Energy Solutions
Atlas Home Energy Solutions
4.1(
34
)
Blown-In Insulation - Install or Upgrade

Serving Adamstown, MD and surrounding areas

Approved

In business since 2009

Free estimates

Credit card accepted

"I selected this company because they are a member of my energy provider's energy saving program network. The customer service was top notch and the insulation installation team was top rate. There was a problem with the aeroseal team assigned to seal any holes in the air vents. The aeroseal solution leaked throughout the house, even into drawers, closets, on clothes, everywhere. It took over a month to clean up. Throughout this process, the owners remained in contact and assisted as best they knew how. The cleanup was stressful, but in the end, all worked out and I have noticed an improvement in energy savings. Thanks!"
Visual Inspection of all Areas of your Home
Attic Insulation and Air Sealing
Infrared Camera Inspection
Attic Spray Foam
Blower Door Whole House Air Leakage Test

+11

Response time1 day
Recommended by87%of homeowners
Avatar for Tri-State Builders
Tri-State Builders
4.6(
104
)
Injection Insulation - Install

Serving Adamstown, MD and surrounding areas

Approved

In business since 2000

Free estimates

Emergency services offered

"These guys were terrific! I hired them to install sound proofing insulation in our basement rec room ceiling. They did two layers of insulation including 1 layer of spray foam. Additionally they hung drywall which saved me a ton of time/money when it came to my general contractor. They were clean, on time, and respectful. They put down floor covering to protect my newly refinished hardwood floors. I would definitely hire this company again! Price was right and so was the service!"
 Kitchen
Barber Addition
Rowland Addition
Custom Home
Traska Addition

+36

Response time3 days
5 neighbors recently requested a quote
Recommended by100%of homeowners
Avatar for ROI Construction LLC
ROI Construction LLC
4.3(
17
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Adamstown, MD and surrounding areas

Approved

In business since 1974

Free estimates

Warranties offered

"We had a great experience with ROI Construction sales representative David Burke. David was very knowledgeable about ROI's porducts and services. We look forward to getting our attic insulation project completed and will provide a more thorough review at that time. Thanks, Tim"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+19

52 neighbors recently requested a quote
Recommended by90%of homeowners
Avatar for Atlas Home Energy Solutions LLC
Atlas Home Energy Solutions LLC
4.9(
106
)
Blown-In Insulation - Install or UpgradeInsulation - Install or Upgrade

Serving Adamstown, MD and surrounding areas

In business since 2009

Free estimates

Warranties offered

"Between Brad K., the company’s support team, and the crews who come out to do the job and execute the work, you cannot select a better company to help you make your home energy efficient and reduce your utility bills by insulating the house and sealing your duct work. As for Brad K., the job begins with Brad coming to your house and conducting an Energy Audit. This gives everyone a far better understanding as to what needs to be done in your home. And, Brad concludes with conducting a “ Test Out,“ to see the improvements. Pepco will offer you a partial rebate for the work completed and they are very satisfied with a 20% reduction. As for us, we hammered Brad with dozens of questions over the course of time before and after we ratified an agreement. In every case, Brad was extraordinarily responsive especially with him being burdened performing audits throughout the day and being offsite. We couldn’t be happier with Brad’s performance. The same goes for the inside team including Jeff, Gordon and Ashley. And, everyone of the guys and their team leads who came to the house not only focused on executing their expertise, but were also very customer focused. In our case, the “test out demonstrated a 36% reduction,“ and Brad believes the partial rebate will be even greater. A Little Constructive Feedback Here: Be sure to ask and fully understand what needs to be done prior to the crews arriving. We had three teams over three days (not in a row) and learned at that moment what more needed to be done to fully finish the job. This will minimize to virtually eliminate any further challenges for the crews and yourselves. However, the job was completed. Over the next 45 days or so, after our utility bill fully cycles, we look forward to seeing the results of Atlas’s work and the reduction in our utility bills. Atlas Home Energy Solutions is Your Best Buy. We are certainly available to provide any further references. RichandJames Peterson Silver Spring, MD (301) 592-1616 Email: [email protected]"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+16

Response time3 days
Response rate100%
2 neighbors recently requested a quote
Accurate Insulation - Home Facebook
4.2(
152
)
Blown-In Insulation - Install or UpgradeInjection Insulation - Install

Serving Adamstown, MD and surrounding areas

In business since 2005

Free estimates

Credit card accepted

"We needed insulation applied only to the underside of the house at this time. The guy who came out to give an estimate was great. The guy that came out to do the spray job (I expected a team and got just one guy) was super nice. The spray foam would appear to be difficult to manage during application as some spots only have a skim of insulation while others seem to have 7 inches of it. The office..... trying to get any information from that office.... was a hassle way beyond my wildest nightmares. Getting the estimate took days, getting scheduled took days. They have only one person working to do all of the scheduling and she "is out of the office" during a whole heck of a lot of "our office hours are from...". Figuring out what I needed to know to pay online took pulling teeth. It was the best price I got and it will make a world of difference to that house structure and its moisture issues.... but good grief!"
Response time2 days
Recommended by97%of homeowners
Cameron Home Insulation
4.6(
40
)
Blown-In Insulation - Install or UpgradeInjection Insulation - InstallInsulation - Install or Upgrade

Serving Adamstown, MD and surrounding areas

In business since 1907

Free estimates

Credit card accepted

"Debbie, the AC&R salesperson, was very knowledgeable and confident. They were the 2nd quote I got for work and came in even lower than I expected (which gave me pause as a low bid is a red flag). But true to her word, they did the work professionally (mostly...see below) and promptly. While I had another company do the energy audit for the Pepco rebate, AC&R took over the work, did the blown fiberglass one day and the spray foam the next.



For the blown fiberglass in the attics above our additions, they added spray foam (from a can) around any gaps per the contract and foam board baffles at the soffits. The installer noted that all our soffits were blocked and the batting insulation was too wide for the rafter channels, so he leveled it out as best he could to ensure an even coating of blown insulation. At the end, he sealed up the gaps between the attic and our to-be-finished upstairs (cape cod style, so all one room).



For the spray foam insulation, the team came in the next day, and I had to be out of the house due to fumes. I did come back around noon as they expected to be done well before then. They didn't know I came in and I went to the back of the house to watch TV on my work break. The one annoyance was during their cleanup, one of the installers came down into our kitchen and then saw me. He said he was looking for a vacuum cleaner to clean the stairs. I told him don't worry about the carpet as it was getting pulled up, but this was the one piece of unprofessionalism I noted above. Contractors should NEVER use the homeowner's property; they should bring their own tools, including vacuums!



While the spray foam can get very messy, they kept the splatter mostly contained to inside the crawlspace, not the finished flooring. However, I was surprised that they didn't tape off the outlet covers or light switched. since the particles are so small, we're going to have to replace the switches/receptacles at our cost. Also, there was a storm door screen that wasn't covered and now needs cleaned. Basically, I think they should have taken more care in covering the very few items we left upstairs and the outlets/switches.



They didn't spray around the window frames (large gaps where window weights used to be) because the open cell foam would expand too much. If I wasn't there, I think they would have just left, but it was clear in our contract discussions they needed to insulate those spaces too. They used a few cans of "Good Stuff" equivalent, but didn't fill in the gaps entirely. It did the job well enough, but it's a ding against them as I expected more preparation.



Lastly, I thought that AC&R would walk me through all the scheduling and final "test out" (for the Pepco rebate), but I had to contact them and schedule with someone different each time. They were always prompt, but I expect the experts to know to do this for/with me rather than expect me to know the process. I go through it once in a lifetime while they do it weekly.



While the end of the review sounds more negative than positive, I would definitely recommend AC&R out to others as they're priced right, they have been in business for over a century, and like any contractor, you just need to follow up to be sure everything is done to your satisfaction.
"
Recommended by100%of homeowners
...
Showing 1-10 of 63
Drywall Insulation questions, answered by experts

Drywall repair is typically completed within a day, depending on damage extent.

You can put certain types of plaster over other types, but doing so isn't always the best idea. For example, putting a coat of gypsum over lime plaster is possible, but doing so will limit the lime plaster's breathability and potentially affect its performance.

Since cement plaster tends to leave a textured surface, no matter how much you smooth it, some people prefer to use gypsum plaster as a topcoat over cement plaster, creating a smoother surface.

In most cases, no, you won’t need a permit to replace drywall. If you’re changing the floorplan of your home by adding or removing walls during the drywall project, then you might need a permit, but replacement or repairs usually doesn’t require a permit. Your drywall professional should be able to confirm whether or not a permit is required for your project. If it is, it’s likely to add between $50 and $150 to your total cost. Keep in mind that you will need permits if you plan to install new electrical wiring or plumbing lines behind your new drywall.

Although they are used for similar tasks, spackle and joint compound are not the same. Joint compound, also known as drywall mud, consists of limestone and gypsum and is primarily used for large-scale projects like taping and finishing seams on new drywall. Spackle is composed of gypsum and binding agents, making it a thicker compound best suited for small wall repairs like filling nail holes or cracks, as it dries quickly and is easy to sand. For small repairs, either product can be suitable. However, you can use joint compound for small jobs in place of spackle, but you cannot use spackle for large-scale taping and mudding projects.

Yes, it matters which side of drywall you use. One side is smooth, and the other is rough. The smooth side should be facing outward, toward the room, while the rough side should be hidden and facing the studs and framing of the house. The smooth side will be easier to apply tape, joint compound, and, later, paint to.

The Adamstown, MD homeowners’ guide to drywall insulation services

From average costs to expert advice, get all the answers you need to get your job done.