"The team is amazing. Formerly known as Atlas, H2O Care is professional and technical. I had many, many questions since I'm installing an new heating and hot water system. The newer technology is higher efficiency, so need to pay more attention to water quality. The tech team is fabulous, especially David who put up with my many, many questions. Highly recommended, especially in areas with very hard water."
"My house had no water coming out of our faucets so I did some research and found Clear water and pump well service I called spoke to a nice ladyon the phone she made a appointment for the next day ,when the came and they told me it was the well water pump needed to replaced so they fixed it plus they also said needed to replace the well tank in the house and they fixed that too,. I highly recommend Clear Water and Pump &Well."
"They were very fast to respond to my call and were able to send someone within two hours. The replacement of the hot water heater went well. For the water pipes they use copper crimp fittings instead of soldering so it will be interesting to see how that holds up over the years. My only concern is how they ran the gas line. They use Gastite CSST which is fine, but the CSST is run so it goes downward then back up and then downward again before it enters black pipe that has a moisture trap. It seems to me that if there is any moisture it will end up in the CSST instead of the trap. In addition, there is a pretty good bend in the CSST right before it goes into the trap section. Also, Teflon tape was used on the all the joints instead of joint compound. I think I will get someone from a different company to come in and take a look at it."
"Clean Water Pump and Well Service was very responsive when I had no water. They even tried to guide me through solving the problem using Facetime over the phone. They are experts at what they do. I highly recommend them."
"Good experience overall. Micah was very knowledgeable. Was surprised to see that all of the suggested options were proprietary. Very expensive but seems like options would certainly address the needs I am seeking. Will possibly utilize one or two options/products but not all. "
"Ryan and his team were friendly, knowledgeable, fast and the price was fair. They were available right away to fix my water heater issue. Great communication, honestly went above and beyond what we were expecting. We highly recommend them."
I pride myself on my professionalism, as well as my ability to complete every job to the homeowner's total satisfaction. I never leave a job unfinished, or a homeowner not 100% satisfied with my level of service - Call today! \n
Installing a water softener could help reduce calcium buildup in your pool if your pool has high calcium hardness as a result of hard drinking water in your home. Pool softeners work by exchanging calcium and magnesium for sodium, so if you use softened water to top off your pool, it may help keep calcium hardness from rising over time. However, it won’t lower the calcium hardness of the water already in your pool and isn’t a practical way to control pool calcium levels. The average water softener installation cost is between $200 and $6,000.
No, hard water isn’t dangerous. The added calcium in hard water can contribute to good bone health. However, it can also cause dry skin and hair. If you have dry skin or hair, consider using a water-softening system to help minimize the minerals in your water. Plus, these systems can also add some sodium to your diet.
Yes. To get soft water, you can install a water softening system, which will replace the calcium and magnesium ions in the water with sodium or potassium ions. Water softeners cost anywhere from $200 to $6,000, depending on the size and complexity of the system. You can either install a water softener for the whole house or just at your shower heads. If you’re sensitive to sodium or potassium, you can install a salt-free water conditioner.
You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips.
The average cost to install a water softener, including the system and labor, is approximately $1,500. However, the total price can range widely from $600 to $6,000. For some complete systems, the cost may be between $800 and $2,500. Labor for the installation typically costs between $150 and $1,000.
The final price is influenced by several factors, including:
System type, capacity, and complexity
Home size and household water demands
Water hardness levels
Accessibility of the installation site and the extent of plumbing work required
Whether new electrical work is needed
The professional hired and any local permit costs
The Hanover, MA homeowners’ guide to water softener services
From average costs to expert advice, get all the answers you need to get your job done.
Learn about water filtration system costs in Boston, MA, average prices, key cost factors, and ways to save on installation and maintenance for your home.
How much a water softener costs in Boston, MA, depends on your home’s size and the system’s type and capacity. Our expert guide explores all the price factors.
Water softeners work to remove unwanted minerals from hard water through a filtration and recharge cycle. Keep reading to learn how a water softener works.
There are four common softener alternatives available on the market today. We compare and contrast each one to help you find your best-fit solution in this blog.
Water softeners rid your home of hard minerals and, well, soften your water. Even better, the regeneration process is an automatic cycle that works when you’re least likely to use it.
