Get matched with top plumbers in Glenmora, LA

Adding a shower to a half bath transforms it into a three-quarter bath. Compared to converting a half bath into a full bath, this type of conversion is a more affordable way to add functionality and accessibility. This project can add around 5% to 6% to the value of your home, especially if you only have one full bathroom or your only shower is on an upper level. This is a common upgrade for a ground floor when homeowners are hoping to age in place.

In the warmer months, it’s fine to leave your garden hose attached to your spigot. However, before the first frost of the year, make sure to disconnect your hose from your outdoor faucet and drain any leftover water inside. Otherwise, water could freeze in the hose and potentially burst inside your faucet or pipes.

No, a larger well pressure tank will not increase your home's water pressure by itself. Water pressure is determined by the pressure control switch on the well pump.

However, a larger tank does offer other benefits. It can store more water, which allows you to run water for longer periods before the pump needs to turn on. This reduces how often the pump cycles on and off, leading to less wear and tear on the pump and the entire well system. Consequently, a larger tank can help extend the life of your equipment and may prevent future pump issues that could affect water pressure.

If your goal is to increase water pressure, consider these alternatives:

• Adjust the pressure settings on your tank to a higher PSI (pounds per square inch).

• Replace your current pump with a model that has a higher flow rate, measured in gallons per minute (GPM).

• Have a professional install a water pressure booster pump in your plumbing system.

• If you experience pressure fluctuations, consider upgrading to a constant pressure system.

In the best-case scenario, the pipe size is written on the side of the pipe. You’ll often find this with different types of plastic piping like PVC, PEX, or CPVC. For other types of pipes, you’ll have to measure. You can measure the outside circumference with a soft tape measure, then divide your measurement by pi. From there, you’ll have to use a conversion chart to get the nominal pipe size (the size you’d buy in the store).