Best water heater pros near Brook, IN

Going from a tank to a tankless water heater is one of the most effective ways to lower your utility bills. The switch also frees up more space and ensures a consistent hot water supply, as the water is heated on an as-needed basis. It costs between $5,400 and $7,400 to install a new tankless water heater. Most installation companies will also help dispose of your old water tank.

Most hot water heater manufacturers recommend replacing the anode rod about once every three to five years. Anode rods sacrifice themselves by collecting iron, limestone, and other minerals that would otherwise corrode your hot water heater tank. This abuse wears them out long before your water heater does. Check the rod when you remove it and replace it if more than 50% of the metal has been consumed. Check the rod more frequently if you have hard water or use a water softener. 

While a water heater explosion is rare, it is a serious danger. Be aware of these critical warning signs:

• Sulfur or Rotten Egg Smell: This is a major red flag, especially for gas water heaters. It can indicate a gas leak, which could ignite and cause an explosion.

• Leaking Pressure Valve: If the temperature and pressure (T&P) relief valve is leaking, it may not be able to properly regulate internal pressure, creating a risk of bursting.

• Shaking or Rumbling: Loud rumbling or shaking from the tank can be a sign of extreme pressure buildup.

• Excessive Heat: If the exterior of the water heater feels unusually hot to the touch, the unit may be overheating dangerously.

• Rust-Colored Water: This can be a symptom of severe internal corrosion that compromises the tank's integrity.

If you notice any of these signs, especially a gas smell, you must act immediately. Shut off the gas supply to the water heater and call a professional plumber right away to prevent a potential disaster.

Yes, this would be an appropriate choice. In order to comply with the National Electric Code’s rules, you'll need to install a circuit breaker that's 125% larger than the intended load. In this case, you'll multiply 30 amps by 1.25 to find the necessary breaker size. Plugging that equation in for your 30-amp water heater will leave you with a 37.6-amp breaker. If your current water heater keeps tripping the breaker, it might be time to talk to a plumber or electrician about upgrading your water heater's setup.