Get matched with top paving pros in Clayton, IL

Maintaining a driveway depends on the material your driveway is made of. Concrete and asphalt should be sealed to protect against water and freeze-thaw cycles. Cracks and expansion joints should be filled with a flexible polyurethane caulk or asphalt sealer. Before you apply a sealant to your driveway, consider pressure washing the surface. It will take off any loose sealant and any grime that might have caused a stain. Sealing over dirt and stains will trap it under the sealer.

If you live in colder climates, consider using sand rather than salt to de-ice. Sand helps melt the snow and ice without speeding up the freezing and unthawing process of your driveway, which helps prevent cracks from forming from the constant fluctuation of temperatures.

The most common alternatives to a gravel driveway are concrete, asphalt, brick, and permeable pavers. Concrete and asphalt are the two more affordable alternatives, while the intricate design options of brick and permeable pavers make installation significantly more expensive. Similar to gravel, concrete isn’t the best driveway material for cold weather, as frigid temperatures can cause it to crack. Alternatively, asphalt is sensitive to heat, and driveways can become soft in areas with high temperatures and sun exposure. While brick and permeable pavers give homeowners curb appeal, the latter offers the added functionality of preventing flooding and reducing runoff water.

The layer of polymeric sand under the pavers plus the polymeric sand that gets swept into the joints between your pavers holds them in place in a few ways. For one, the gritty texture of the sand helps lock the pavers together. Polymeric sand also contains bonding agents that get activated by water. Polymeric sand will take between 24 and 48 hours to fully cure, so do not walk on your paver walkway before this time.

Box fill refers to the maximum number of conductors that can be contained within a wiring enclosure box, as well as the total volume of the components. Determining the allowable number of conductors in a box requires adding up the number of conductors, clamps, support fittings, devices and equipment, and equipment grounding conductors to make sure you’re within the allowable volume.