Get matched with top masons in Gunbarrel, CO

The cost of masonry work varies widely depending on the type of masonry along with common cost factors like size, complexity, location, and season. Most exterior masonry work done in freezing temperatures tends to cost more because of the preparation and protection involved to keep the masonry from freezing before the mortar cures properly. The average price ranges per project or square foot for different types of masonry include:

• Brick wall (fence, garden wall, etc.): $10–$45 per square foot

• Natural stone wall: $40–$110 per square foot

• Manufactured stone veneer: $20–$40 per square foot

• Brick home exterior: $10–$30 per square foot

• Brick siding: $3–$10 per square foot

• Stone siding: $35–$50 per square foot

• Brick step replacement: $20–$30 per square foot

• Brick wall repair: $20–$40 per square foot

• Chimney repairs: $160–$750 per project

• Tuckpointing: $5–$25 per square foot

It is possible, albeit a lot slower, to break up a rock using water. You would do this by freezing and thawing the water. You could create some initial holes or cracks in the rock, then pour water into the cracks or holes and allow them to freeze (so it's best to do this in winter or in colder climates). Since water expands when it freezes, this puts pressure on the inside of the rock and causes it to crack. You could continue to pour more water in and let it freeze to continue to break up the rock.

Handbuilt masonry fireplaces are likely what comes to mind when we think about curling up by the fire at the end of the day. But bricks in the firebox and chimney tend to be heavy, which is not ideal for homes with weak or damaged foundations.

Prefabricated fireboxes come with a full flue and chimney system, significantly reducing the price and installation time. However, if you need to replace the panels down the line, you are locked into the same model or something very similar.

Yes, you can do German schmear on stone. You can account for the more textured and rough surface of stone by using a large paintbrush instead of a putty knife. A brush allows you to drag mortar across the stone to get it into all the cracks and crevices. However, a brush will cover more of the surface, so you may need a wet sponge to scrub excess mortar and expose more of your stone.