Get matched with top toilet pros in Coalinga, CA

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

Most toilets have a 12-inch rough-in or hole, but some have 10- or 14-inch holes, which means that not all toilets fit all setups. Knowing how to measure the rough-in is essential, so you purchase a toilet that fits the existing drain hole. It can be costly to have the rough-in moved, and most stores don’t accept toilet returns.

Even though they’re modern-looking, easier to clean, can be hung at any height, and help save space compared to traditional toilets, wall-hung toilets have some downsides. They’re more expensive than standard toilets, sometimes by a few hundred dollars. They’re also difficult to install and may require major plumbing work to reroute the drain if the previous toilet was a floor-mount model.

This tight fit can make repairs more difficult. You’ll also have to consider where you can hang them and weight limit restrictions, so they may not be the best fit for every home.

A bit of water in the bowl can help unclog a toilet, especially if you're using a plunger. However, if the bowl is full to the brim, you'll need to strap on gloves and remove some of the wastewater in a cup or container so it doesn't overflow when you try to unblock the pipe. If you're concerned about it filling further, manually close the flapper in the toilet tank or turn off the water supply to the toilet.