Get matched with top toilet pros in Tranquillity, CA

To test for toilet leaks, use water coloring in the water tank and see if the water slips into the bowl from the tank. This test will indicate if there’s a problem with the flapper or refill tube. You can also put water coloring in the bowl of the toilet to see if there is a leak there. If there is, you should see the colored water on the outside of the toilet bowl or on the floor. 

The amount of water wasted when a toilet ghost flushes depends on the cause of the ghost flushing. Leaky flapper valves tend to waste less water than a larger problem like a damaged flush valve that makes the toilet run constantly. Even if you don’t think you’re wasting a lot of water, it’s still a problem that should be fixed quickly. 

Yes, frozen pipes can cause a toilet to stop working correctly. If the pipes are frozen, water cannot flow, which can lead to two main problems. First, the supply line to the toilet tank may be frozen, which prevents the tank from refilling with water after you flush. Second, the drain pipe itself can freeze, blocking water from flushing away. As a temporary solution for a non-refilling tank, you can manually add water, but this is not a long-term fix. To clear a frozen drain pipe, you can try pouring warm water into the toilet bowl or tank and then flushing, as the warm water may help thaw the ice blockage. Ultimately, the best course of action is to unfreeze the affected pipes to restore your toilet to full functionality.

The cost to install a new toilet typically runs from $225 to $530. This doesn’t include the price of the toilet itself, which can cost $90 to $1,500 depending on the model and features you choose. You can save money if you choose to install a toilet yourself. However, you might want to hire a pro for this project.

"Due to the many complexities of replacing a toilet flange, it is typically a job best left to the pros," says Jeff Botelho, Angi Expert Review Board member and plumber. "Many times it isn't as simple and straightforward as 'pop off the old one and pop on a new one' because the flange is either glued on (PVC/ABS), soldered on (brass/copper), or caulked in place with a lead & oakum joint (cast iron) and none of these things can be easily reversed without years of training and repetitive practice."