Get matched with top pressure washers in Acton, CA

Sodium bicarbonate does not need to be cleaned up as thoroughly as many of its aggregate counterparts because it is not considered dangerous to the environment, nor to pets or people. While you will likely want to clean up the dust with a shop-vac and some water for aesthetic and comfort reasons, soda blasting cleanup is much simpler than for most sandblasting.

We don’t recommend pressuring washing clapboard siding. At high levels of pressure, a pressure washer can damage wood siding permanently. Pressure washing can also make it easier to drive water into the cracks of clapboard (which are recommended for easier drainage), causing moisture damage.

If you think your clapboard siding is so dirty it could benefit from pressure washing, we suggest contacting a pressure wash cleaning service and getting a quote on a wood siding project. Some siding manufacturers recommend never pressure washing because it can force water behind the siding.

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.