Get matched with top pressure washers in Saugus, CA

The best and fastest way to remove paint from a deck often involves combining a chemical stripper with a pressure washer. Gel-based paint strippers are highly recommended because their thick consistency makes them less messy and easier to apply than liquid strippers. After applying the stripper to loosen the paint, you can use a pressure washer to efficiently wash away the residue. When using a pressure washer for this task, it's important to use a low pressure (under 1000 PSI) to avoid forcing too much moisture into the wood, which could lead to mildew or rot.

The average cost to pressure wash a house is around $310, with typical prices ranging from $200 to $420. However, the total cost can vary widely, from $200 to $750. Power washing, which uses heated water, may cost between $250 and $400 per project, with an average of $200 to $300 for a 2,000-square-foot home.

Key factors that influence the final price include:

• The size and height of the house (a multi-level home costs more than a single-story one).

• The complexity of the job and accessibility of certain areas.

• Geographic location.

• Equipment and hourly labor costs.

Hiring a professional is often recommended as they bring their own equipment and cleaning solutions. Experienced professionals know how to complete the job effectively without causing damage to your siding, gutters, or landscaping, which can be a risk with high-powered water jets.

If the exterior walls are not thoroughly cleaned before a paint job, the paint could stick to the grime, creating obvious imperfections along the way. Beyond that, painting over a freshly-cleaned wall just about doubles the lifespan of the paint, from three or four years to seven to ten years. 

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.