Best countertop and backsplash pros near Prescott, AZ

Most countertops come with a standard eased edge design as part of their fabrication cost, so that edge style will not cost extra on top of the countertop fee. Eased edges are simple, elegant, and have a classic look. Square edges are also inexpensive to add to most types of countertop material, and they look good with most contemporary home styles. If you redo your kitchen cabinets or kitchen style, they are likely to fit the new style, so you will not need to change countertops or have the edges recut, which can save remodeling costs in the future.

While Formica® countertops are scratch-resistant, they are not fully scratch-proof. They will develop marks on their upper decorative layer more easily than quartz, granite, or porcelain tile. Always use cutting boards for food prep and avoid dragging heavy items, such as blenders or big pots, across the surfaces.

You can cut food on tough, scratch-resistant granite countertops. However, these hard surfaces can quickly dull your knife blades, and continual cutting in the same spot can eventually lead to marks forming and compromising the protective sealant. As with any countertop material, it’s always best to use a chopping board.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.