Top-rated lead testing and removal specialists.

Get matched with top lead testing and removal specialists in Cross Plains, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your lead testing and removal project in Cross Plains, WI?

Select your specific project to find the pro for you.

Find Lead testing and removal specialists in Cross Plains

Avatar for Umbrella Environmental
Umbrella Environmental
5.0(
28
)
Toxic Lead - Abatement

Serving Cross Plains, WI and surrounding areas

Approved

Super Service Award Winner

In business since 2010

Free estimates

Emergency services offered

"Highly recommended. We needed our attic tested for Asbestos before putting new roof and insulation in. Todd returned my call immediately, patiently answered all of my questions and tested the attic next day. This was great, because the roof was going up 3 days later! Luckily there was no asbestos and we could proceed with the work. I’m very grateful for Todd and Umbrella Environmental."
Rec Room - Before.  This is the room before any work was performed.
Asbestos containing wrap on ductwork - Before
Rec Room - After.  The asbestos containing floor tile and the asbestos containing mastic was removed from this basement located in Milwaukee, WI.
Ductwork with asbestos wrap removed.
The adhesive used on the wood furring strips contained asbestos and needed to be removed by Umbrella Environmental Services.

+11

Response time1 day
Response rate100%
9 neighbors recently requested a quote
Lead Testing and Removal questions, answered by experts

Sampling typically takes 1-3 hours, and depending on the provider, lab results are available within 2-7 days.

If lead is detected in a property, steps should include arranging for professional removal or containment, notifying all occupants, and implementing interim safety measures to reduce exposure.

When a surface that contains lead dust is disturbed, the dust can float about in the air for roughly an hour before settling again. Since you cannot see the dust, it is important always to wear protective gear when working with any materials that may contain lead paint and to keep children, pets, and others away from the area for as long as possible

Costs depend on test type, home size, number of testing locations, and whether follow-up testing is required.

Several different measurements may be used to determine the amount of lead in water. The most common unit of measurement is micrograms per liter (µg/L), which is the same as parts per billion. Another measurement is milligrams per liter (mg/L), which is the same as parts per million.

The Cross Plains, WI homeowners’ guide to lead testing and removal services

From average costs to expert advice, get all the answers you need to get your job done.