Get matched with top well and pump technicians in Bothell, WA

"We called Bob when one morning when it was 15 degrees and our well pump stopped running. No frozen pipes. Bob quoted the cost to visit and take a look however first proposed a procedure we could try first and avoid the charges. It worked Great and we had water again within 20 minutes. The next morning our neighbor called with the same problem, we suggested Bob'and our neighbor need Well & pump service it will be his number s procedure and again a running pump! We really appreciate Bob's knowledge and willingness to solve our problem 's without cost . When wewe call. Much appreciated and Thank-You A-Plus Water Services, Inc and Bob. Gail & Terry Johnson Maysville Wash."

"Zach and his crew were amazing! Our old water heater sprung a massive leak at 2:00am on a Saturday morning. Contacted Zach at 7:30am and he called right back and was here within the hour. Not only did we replace our water heater with a tankless model, but also moved it from the second floor to garage. Zach did all of this on a Saturday for a flat fee!! He and his crew were here for 9 hours without complaint or even seeming to take a rest!! Knockout Plumbing is indeed a 'Knockout' and I would highly recommend!! Kudos to all!!"

"I have given my friends/neighbors your name and number. PLUMBER came out in about 2 hrs. He found the problems immediately. I was very pleased with his estimate and work. He was $1,000 cheaper than another plumber quoted me to fix the problem."

"Aaron and his team did an excellent job from start to finish, and I’m completely satisfied with their work. They installed my Tesla car charger efficiently, and I would gladly recommend them and use them again for any future electrical needs."

"Very happy with the entire experience. Got an estimate which was the lowest of the 4 plumbing companies that I contacted for the job. I felt the price was reasonable and pretty close to the price I thought it would cost. The job was done at the agreed upon estimate quote price, no additional cost after the fact. I was able to schedule the job next day. The Plumber was on time and only took him 1 1/2 hours to complete the job. Work was very well done and very happy with result. Cost - $1,339.00 + Tax."

"One could not ask for much more with Vlad from AWP. He was willing to take the time to discuss what he was doing and explain options. His work is very neat and precise and he maintained a very clean work environment. As someone who does most of their own work, I can assure you that I will utilize AWP for all my plumbing needs in the future."

"Fred is the best plumber we’ve ever used. He’s fair, honest and talented. Already recommend him to friends and neighbors, and now you can too. You will not regret calling Fred for your plumbing needs."

"The installation of our new heat pump was to take two days, and I assumed would be done during normal business hours (8:00AM - 5:00PM). I expected a smooth process and a properly working system at the end of the 2nd day. The experience was not even close to my expectations. Day 1: Old air handler, heat exchanger, compressor pad and compressor were removed; new air handler, heat exchanger, and compressor pad were installed. As expected, the new compressor was placed on the pad, but not connected to inside unit. I observed one of the four-man crew scraping gravel from my neighbor's driveway to put under the compressor pad. When I told him that my neighbor probably would not like that, he said, "It will be OK. I'll smooth out the places I took it from." He couldn't have given a more wrong answer! Late in the afternoon, the electrician (an Overlake subcontractor) arrived to hookup power to the new system, and all four from the installation crew left. (I think at least one of the crew should have stayed until the electrician was finished to verify that the system was working. And maybe to explain to me how to operate the new thermostat!) About 90 minutes later, the electrician was finished, but the system would not turn on. It was not his job to troubleshoot system problems, but with the guidance of someone over the phone, he managed to find two wires that had not been connected by the Overlake crew. He connected the wires, but that made no difference. I was supposed to have backup electric heat working at the end of Day 1. This was important because it was December and the temps were down to 32 degrees at night. After 2 hours of trying to get the system to produce heat, the electrician left at 7:00PM, and an Overlake tech arrived at 8:30PM. At 10:00PM, the tech determined that a circuit board in the air handler was defective, and a new one would have to be obtained and installed in the morning. I managed to get by with two 1500-watt space heaters by closing off most of the rooms. Day 2: Before the techs arrived, I noticed that the compressor pad, with compressor installed on it, was significantly out-of-level. The techs arrived at 10:30AM, and I asked them to purchase a bag of gravel to replace what had been taken from my neighbor’s driveway, and they complied with my request. I also asked them to level the compressor pad which they did. The defective circuit board was replaced, and backup electric heat came on. It took two Overlake techs until 7:00PM to connect the inside and outside units of the heat pump, and attempt to charge the system with refrigerant. However, a valve on the compressor unit was leaking so the heat pump could not be operated until a new valve was obtained and installed the following day. Day 3: Two Overlake techs arrived at 1:30PM, and, I assume, they installed a new valve. What appeared to me that was left to be done at that point was to charge the system with refrigerant, connect a small electrical cable between the inside and outside units, insulate the refrigerant lines, and spot-tie the lines and wires into a neat installation. This seemingly small quantity of work took until 10:00PM to complete, at which time it appeared that I had a working system. Day 4: I had programmed the wi-fi capable thermostat using the owner’s manual on Day 2, so I woke up on Day 4 to two emails from the system telling me about urgent notifications that had occurred in the middle of the night. They were Error Code 99’s – High Torque Lockout. A google of this returned a manufacturer’s document that explained this code was likely due to overcharging the system, and resulted in the compressor shutting down for a while and then restarting for a couple of hours when the error situation occurred again. I called Overlake and they said to run the system only on the electric backup until a tech could come out 4 days later. I think Overlake should have sent a tech out that day since, at that point, they were already two days late providing me with a working system. Also, since my old but still working heat pump had been turned off 3 days before, I was going to be using electric backup for 7 straight days (at least), and that more than doubles my heating bill, at this time of year. Days 5 thru 7: Waiting for tech to return and troubleshoot error code. Day 8: Appointment for tech was scheduled for between 11:00AM and 1:00PM. Tech arrived at 4:00PM, but did call to say he would be late. Between 4:00PM and 10:00PM, the tech removed the refrigerant from the system and then recharged the system with refrigerant. He had determined that the initial charging had been below spec (too little refrigerant was used), and he said that the system should work OK now that it was properly charged. After the crew left, I noticed that there was dirt, installation scraps, and some kind of cream-colored lubricant on the carpet next to the air handler, as well as trash in the crawl space and outside around the compressor unit. In general, they could have done a better clean up. Also, they apparently used the top of our clothes dryer as a work bench since there was a drop of dried, blue PVC solvent on the dryer along with many dirty finger prints. The system has now operated for 5 days without any obvious problems. I now have an installed and operating system; however, given that it arrived from Bryant with two faulty components, and the installation included two wires not connected and improperly charging of the system, I have little confidence in my new Bryant heat pump. However, among all the negative aspects of this project, there were a couple positives: Overlake’s price was almost $2000 lower than their competition, they promptly submitted the necessary data to Bryant for the rebate I was due, and they appeared to provide a neat and proper installation."

"From start to finish job was done professionally and quickly. Price was fair and crew was pleasant to work with. If you’re needing sewer line replacement good place to go to"

"I called Benjamin Franklin Plumbing of Bellevue for a septic tank pump-out, and they were amazing! Tina and Lawrence showed up right on time, got straight to work, and had everything done quickly and professionally. They even took the time to explain the process and gave me tips to keep my system running smoothly. Really great service!"