Get matched with top electricians in Bakersfield, VT

Amps describe the amount of energy that can flow through a circuit breaker. Every electrical device that’s attached to the breaker requires about 1.5 amps. While that equates to roughly 13 receptacles per 20 amps, using slightly fewer ensures that your circuit will always have enough energy for sudden power surges instead of tripping when one occurs. In general, 10 to 12 receptacles is recommended for a 20 amp circuit.

In general, 200 amps is enough for a house with a square footage of up to 1,800, or the average three-bedroom home. A 200-amp service allows your home to warm and cool itself while running multiple appliances at once. It's a good option for homes that have been extended, or after adding new appliances. 200-amp service is the current standard for homes, so in most cases, it will work for you.

If only half of your outlet works, there are usually two possible causes: faulty wiring or a half-hot outlet. The first thing you'll want to do is check the circuit breaker panel to ensure that it's not tripped. If your circuit breaker isn't tripped, turn off the electricity and inspect the wiring to see if anything has come loose or corroded. 

If you have a half-hot outlet, it means half of the outlet is controlled by a switch somewhere on the same circuit, which should be nearby. This is an intentional electrical design commonly found in rooms without overhead lights.

Yes, in some locations, it is required by the National Electric Code (NEC) to have a transfer switch installed for electrical emergencies. In addition to following electrical code, generator transfer switches ensure your home is fully protected during a power outage. By switching the power from the main breaker to the generator breaker, you can seamlessly operate your HVAC, lights, appliances, devices, and more during an emergency.